No abstract

Mechanical properties considerably reduce in wood-plastic composites (WPCs) due to the use of wood particles, so the structural applications of these composites are scarce. Thus, embedding continuous fibers is considered the most reliable method for increasing mechanical properties, although there are still challenges in employing this method on a large scale. In this study, an elaborated, special modular die with the capability of adjusting 14 rovings of continuous fibers was designed, manufactured, and implemented to simultaneously embed continuous glass fibers into the extruded WPC profile. More precisely, it was aimed to investigate the arrangement of fiber rovings into the desired positions in a WPC profile of 70 wt% wood content. Also, the effect of the glass bundle tex (at three level, 1200,2400 and 4800) and the fiber position (at four levels, 0, 2, 4, and 6 mm of relative movement of the guides) on the mechanical properties of WPCs was evaluated. According to the results, the flexural strength of reinforced specimens for 1200, 2400, and 4800 texes increased by 85.8, 107, and 159.7%, respectively, compared with the non-reinforced composite. Theoretical values were calculated and compared with experimental outcomes. Based on the results, The failure mode was non-catastrophic, which means the specimens were able to carry partial loading; a desirable characteristic for the structural applications.

In this study, 3D printing of poly-l-lactic acid (PLLA) scaffolds reinforced with graphene oxide (GO) nanoparticles via Digital Light Processing (DLP) was investigated to mimic bone tissue. Stereolithography is one of the most accurate additive manufacturing method, but the dominant available materials used in this method are toxic. In this research, a biocompatible resin (PLLA) was synthetized and functionalized to serve the purpose. Due to the low mechanical properties of the printed product with the neat resin, graphene oxide nanoparticles in three levels (0.5, 1, and 1.5 Wt.%) were added with the aim of enhancing the mechanical properties. At first, the optimum post cure time of the neat resin was investigated. Consequently, all the parts were post-cured for three hours after printing. Due to the temperature-dependent structure of GO, all samples were placed in an oven at 85 ° C for different time periods of 0, 6, 12, and 18 hours to increase mechanical properties. The compression test of heat treated samples reveals that the compressive strength of the printed parts containing 0.5,1, and 1.5 % of GO increased by 151,162 ad 235%, respectively. Scaffolds with the designed pore sizes of 750 microns and a porosity of 40% were printed. Surface hydrophilicity test was performed for all samples showing that the hydrophilicity of the samples increased with increasing GO percentage. The degradation behavior of the samples was evaluated in a PBS environment, and it revealed that by increasing GO, the rate of component degradation increased, but the heat treatment had the opposite effect and decreased the degradation rate. Finally, besides improving biological properties, a significant increase in mechanical properties under compression can introduce the printed scaffolds as a suitable option for bone implants.