No abstract

Printed electronic paper identifies its interest in flexible organic electronics and sustainable and clean energy applications because of its straightforward production method, cost‐effectiveness, and positive environmental impact. However, current limitations include restricted material thickness and the use of supporting substrate for printing. Here, 2D and 3D electronic patterned paper are fabricated from direct ink writing (DIW) nanocellulose and PEDOT:PSS‐based materials using syringe deposition and 3D printing. The conductor patterns are integrated in the bulk of the paper, while non‐conductive sections are used as support to form free‐standing paper. The strong interface between the patterns of electronic patterned paper gives mechanical stability for practical handling. The conductive paper‐based electrode has 202 S cm−1 and is capable of handling electric current up to 0.7 A, which can be used for high‐power devices. Printed supercapacitor papers show high specific energy of 4.05 Wh kg−1, specific power of 4615 W kg−1 at 0.06 A g−1, and capacitance retention above 95% after 2000 cycles. The new design structure of electronic patterned papers presents a solution for additive manufacturing of paper‐based composites for supercapacitors, wearable electronics, or sensors for smart packaging.

The interphase properties in nanocomposites indicate the interaction between filler and matrix, which is dependent on the preparation method, shape, and size of filler and the chemical interaction between two phases. Local chemical environment in polymer matrix give rise to the different dielectric properties compared to that of bulk material. These properties allow the understanding of their effects on the dielectric properties and glass transition (T g ) of the nanocomposites. In this study, interphase power law model was used to predict the interphase properties based on the experimental dielectric constant of polyimide (PI) with BaTiO 3 , TiO 2 , and ZrO 2 nanocomposites. They were prepared via in situ polymerization of PI whose dielectric constant were increased at interphase filler volume fraction of BaTiO 3 , TiO 2 , and ZrO 2 at 3.8, 2.05, and 1.7, respectively. These results indicate that PI/ceramics nanocomposites had poor dispersion and weak interphase interaction between the filler and the matrix, as an evidence of scanning electron microscopy and Fourier transform infrared spectroscopy results. However, PI incorporated with high aspect ratio of BaTiO 3 nanofiber shows better dispersion than nanocomposites of TiO 2 and ZrO 2 filled PI; therefore provide higher dielectric constant and T g .