In this paper we present an all-fiber vector bend sensor by means of a self-fabricated micro-structured multicore optical fiber. The reported solution is based on differential intensity variations of the light transmitted along the cores whose changes are influenced by the bending angle and orientation. The unique asymmetric structure of the air-holes in the optical fiber provides each core with different confinement losses of the fundamental mode depending on the bending radius and orientation, making each of the cores bend-sensitive in a range of at least 80°. It has been experimentally demonstrated that the reported sensor enables the bending angle and orientation to be detected in a full range of 360° without any dead-zones, and the possibility of end point detection with millimeter precision. Additionally, a reconstruction of the bending vector has been carried out theoretically, and a good match can be observed between the experimental and theoretical data.

No abstract

In this work, a compact all-fiber bend sensor based on a dual-core microstructured optical fiber has been manufactured and characterized. The sensor relies on the unbalanced Michelson interferometric technique realized by attaching a piece of silica fiber to one of the fiber cores acting as the unbalancing element. Three probes with different lengths of the unbalancing element have been experimentally tested for sensitivity tailoring analysis. Additionally, a theoretical model has been developed for comparison and verification of the results. Good linear behavior of the spectral shift with bend has been measured and it has been proven that the sensitivity of the sensor depends on the length of the unbalancing element and the orientation of the cores. Higher sensitivities are achieved for shorter lengths of the unbalancing element and orientation of the core axis parallel to the bend direction. The highest sensitivity reported is 9.97 pm/µm for the case of 34 µm of unbalancing element and orientation of 0 degrees.

<p>An important factor determining the quality of optical fibers is their mechanical reliability. The control of the mechanical reliability allows define the lifetime of a fiber, which was under the stress during the work. Decisive influences on the mechanical and optical properties of the optical fibers have the protective coatings. Optical fiber technology requires that the coatings were applied on them on-line, directly after they have been drawn. So far, little attention has been paid to optimizing the conditions of coatings curing. In this work, the comparison of a thermoanalytical and spectroscopic analysis of coatings that were cured in an UV oven in which the power of the UV lamps was changed will be shown. As part of the research tasks, completed mechanical strength measurements were made with a silica fiber of 0.125 mm diameter.</p>

No abstract