No abstract

A few waste materials, such as demolition waste, steel slag, quarry dust, fly ash are dumped in landfills. This causes environmental issues and pollution. The present study aims to examine the effect of replacing two types of waste materials i.e., quarry dust and steel slag as partial replacement of cement and sand respectively. Cement was replaced partially with quarry dust between 5 to 20% with 5% intervals and sand was replaced by 75% steel slag consistently for all the concrete mixes. The concrete cubes, beams and cylinders were tested for their strength characteristics by measuring compressive strength, flexural strength and splitting tensile strength. The maximum increase of 4%, 34% and 38% in compressive, flexural and splitting tensile strength respectively was observed with 15% quarry dust replaced with cement and 75% steel slag replaced with sand. Based on the present experimental study, partial replacement of these waste materials shall mitigate the issues occurring due to storage and also by utilizing these materials in concrete as replacement for cement and sand resulting in higher strength properties compared to the naturally available construction materials.

Concrete is an essential construction material. Even-though conventional concrete performs and satisfy the structures under normal conditions, a few special situations require very high compressive strength of concrete. An experimental investigation is done to develop high strength concrete with suitable admixtures and steel fibers. The properties of fresh and hardened concrete with alccofine as partial replacement for binder and poly-carboxylate ether (Glenium 8233) and steel fibers is investigated for the workability and mechanical properties i.e., compressive, splitting tensile and flexural strength of concrete. Based on the results, the strength increased with the addition of alccofine compared to the control mix. Hence, by optimum percentage of alccofine, high strength of concrete of 112 MPa can be obtained.