P-T conditions of cataclastic deformation associated with underplating in subduction zone are estimated from fluid inclusions within the post-mélange veins in the Cretaceous Shimanto Belt, Kii Peninsula, SW Japan. Both cataclasite and post-mélange veins cut the mélange fabric and are distributed along the thrusts in duplex structure. The homogenization temperatures range from 200 (±10)• C to 270 (±42)• C corresponding to entrapment pressures over a wide range from 145 (±5) MPa to 304 (−20) MPa. Our results have important implications in evaluating the relationship between underplating processes by duplexing and coseismic deformation in accretionary complexes.

Pressure and temperature (P–T) conditions of mélange formation are estimated from fluid inclusions within “syn‐mélange” veins developed in the necks of boudins of sandstone blocks in the mélange of the Shimanto accretionary complex, south‐west Japan. The mélange records décollement‐zone processes. P–T conditions are in the range of 81 (+15) to 235 (±18) MPa and 150 (±25) to 220 (±31)°C. Assuming a constant fluid‐pressure to lithostatic‐pressure ratio for each data set, we estimate a P–T gradient of between 10.0°C/km (+0.2/−1.5) (lithostatic pressure) and 4.2°C/km (+0.1/−0.9) (hydrostatic pressure) from these results. The estimated lithostatic P–T gradient is much lower than that calculated from the age of the subducting oceanic plate. The estimated P–T conditions suggest that the mélange was formed within the seismogenic zone (hypothesized from thermal modeling), although the deformation mechanism of mélange (i.e. dominant diffusive mass transfer mainly in shale matrix with minor brittle breakage mainly in sandstone blocks) does not show evidence of seismic deformation. In addition, at the time of syn‐mélange vein formation, a shale matrix of mélange has injected into the vein, which indicates a ductile deformation of shale. A possible explanation for this discrepancy is that the mélange was formed during the interseismic period.

No abstract

Abstract:The Takara volcanogenic massive sulfide (VMS) deposit occurs in Miocene formation of the Misaka Mountain, the South Fossa Magna region, central Japan. The tectonic setting of the Misaka Mountain is reconstructed to be a part of the paleo Izu-Ogasawara arc which collided with the Honshu arc and to form accreted body in the present position. The Takara deposit, therefore, is considered to have formed in the paleo Izu-Ogasawara arc.The ores from the Takara deposit are classified into pyrite-type ore, chalcopyrite-type ore, and sphalerite-type ore on the basis of chemical composition and their mineral assemblages. Some pyrite-type ores are characterized by their high Au content. The Au content is hardly recognized in the chalcopyrite-type and sphalerite-type ores.The ores from the Takara deposit have intermediate bulk chemical composition between those from the Besshi-type deposits and the Kuroko-type deposits that are two representative VMS deposits. However, the bulk chemical composition is closer to that from the Kuroko-type deposits. And moreover, chemical composition of tetrahedrite-tennantite series minerals (tetrahedrite) is similar to that from the Kuroko-type deposits. The bulk chemical composition (Cu, Zn, Co, Pb, and As contents) of ores is affected by the chemical composition of volcanic rocks associated with VMS deposits.