TiVO4 photoanode was prepared using the spray pyrolysis technique and further employed for photoelectrochemical water splitting to produce hydrogen.

To optimize the semiconductor properties of TiVO4 thin films and enhance their performance, we incorporated cobalt nanoparticles as an effective co-catalyst consisting of a non-noble metal. Through an investigation into the impact of cobalt loading on spray pyrolyzed TiVO4 thin films, we observed a significant enhancement in the photoelectrochemical (PEC) performance. This was accomplished by carefully optimizing the concentrations of Co2+ (3 mM) to fabricate a composite electrode, resulting in a higher photocurrent density for the TiVO4:Co photoanode. When an applied potential of 1.23 V (vs RHE) was used, the photocurrent density reached 450 μA/cm2, approximately 5 times higher than that of bare TiVO4. We conducted a thorough characterization of the composite structure and optical properties. Additionally, electrochemical impedance spectroscopy analysis indicated that the TiVO4/Co thin film exhibited a smaller semicircle, indicating a significant improvement in charge transfer at the interface. In comparison to bare TiVO4, the TiVO4/Co composite exhibited a notable improvement in photocatalytic activity when degrading methylene blue (MB) dye, a widely employed model dye. Under light illumination, a TiVO4/Co thin film exhibited a notable dye degradation rate of 97% within a 45 min duration. The scalability of our fabrication method makes it suitable for large-area devices intended for sunlight-driven PEC seawater splitting studies.

No abstract