The Ruddlesden-Popper (KNiF) type phase LaNiOF was prepared via a polymer-based fluorination of LaNiO. The compound was found to crystallize in the orthorhombic space group Cccm ( a = 12.8350(4) Å, b = 5.7935(2) Å, c = 5.4864(2) Å). This structural distortion results from an ordered half occupation of the interstitial anion layers and has not been observed previously for KNiF-type oxyfluoride compounds. From a combination of neutron and X-ray powder diffraction and F magic-angle spinning NMR spectroscopy, it was found that the fluoride ions are only located on the apical anion sites, whereas the oxide ions are located on the interstitial sites. This ordering results in a weakening of the magnetic Ni-F-F-Ni superexchange interactions between the perovskite layers and a reduction of the antiferromagnetic ordering temperature to 49 K. Below 30 K, a small ferromagnetic component was found, which may be the result of a magnetic canting within the antiferromagnetic arrangement and will be the subject of a future low-temperature neutron diffraction study. Additionally, density functional theory-based calculations were performed to further investigate different anion ordering scenarios.

Fluoride ion batteries (FIBs) are a recent alternative all-solid-state battery technology. However, the FIB systems proposed so far suffer from poor cycling performance. In this work, we report La 2 NiO 4.13 with a Ruddlesden-Popper type structure as an intercalation-based active cathode material in all solid-state FIB with excellent cycling performance. The critical charging conditions to maintain the conductivity of the cell were determined, which seems to be a major obstacle towards improving the cycling stability of FIBs. For optimized operating conditions, a cycle life of about 60 cycles and over 220 cycles for critical cutoff capacities of 50 mAh/g and 30 mAh/g, respectively, could be achieved, with average Coulombic efficiencies between 95-99%. Cycling of the cell is a result of fluorination/de-fluorination into and from the La 2 NiO 4+d cathode, and it is revealed that La 2 NiO 4.13 is a multivalent electrode material. Our findings suggest that La 2 NiO 4.13 is a promising high energy cathode for FIBs.

Composite electrolytes comprising a polymer plus Li salt matrix and embedded fillers have the potential of realizing high lithium-ion conductivity, good mechanical properties, wide electrochemical operational window, and stability against metallic lithium, all of which are essential for the development of high-energy-density all-solid-state lithium-ion batteries. In this study, a solvent-free approach has been used to prepare composite electrolytes with tetragonal and cubic phase garnets synthesized via nebulized spray pyrolysis with polyethylene oxide (PEO) being the polymer component. Electrochemical impedance spectroscopy (EIS) is used to examine a series of composites with different garnets and weight fractions. The results show that with the increase in the ceramic weight fraction in the composites, ionic conductivity is reduced and alternative Li-ion transport pathways become accessible for composites as compared to the filler-free electrolytes. An attempt is made to understand the ion transport mechanism within the composites. The role of the chemical and morphological properties of the ceramic filler in polymer-rich and ceramic-rich composite electrolytes is explained by studying the blends of nonconducting ceramics with the Li-conducting polymer, indicating that the intrinsic conductivity of the ceramic filler significantly contributes to the overall conductive process in the ceramic-rich systems. Further, the stability of the garnet/PEO interface is studied via X-ray photoelectron spectroscopy, and its impact on the lithium-ion transport is studied using EIS.

Within this article, it is shown that an electrochemical defluorination and additional fluorination of Ruddlesden−Poppertype La 2 NiO 3 F 2 is possible within all-solid-state fluoride-ion batteries. Structural changes within the reduced and oxidized phases have been examined by X-ray diffraction studies at different states of charging and discharging. The synthesis of the oxidized phase La 2 NiO 3 F 2+x proved to be successful by structural analysis using both X-ray powder diffraction and automated electron diffraction tomography techniques. The structural reversibility on re-fluorinating and re-defluorinating is also demonstrated. Moreover, the influence of different sequences of consecutive reduction and oxidation steps on the formed phases has been investigated. The observed structural changes have been compared to changes in phases obtained via other topochemical modification approaches such as hydride-based reduction and oxidative fluorination using F 2 gas, highlighting the potential of such electrochemical reactions as alternative synthesis routes. Furthermore, the electrochemical routes represent safe and controllable synthesis approaches for novel phases, which cannot be synthesized via other topochemical methods. Additionally, side reactions, occurring alongside the desired electrochemical reactions, have been addressed and the cycling performance has been studied.