Previous studies have shown that timing of sensory stimulation during the cardiac cycle interacts with perception. Given the natural coupling of respiration and cardiac activity, we investigated here their joint effects on tactile perception. Forty-one healthy female and male human participants reported conscious perception of finger near-threshold electrical pulses (33% null trials) and decision confidence while electrocardiography, respiratory activity, and finger photoplethysmography were recorded. Participants adapted their respiratory cycle to expected stimulus onsets to preferentially occur during late inspiration/early expiration. This closely matched heart rate variation (sinus arrhythmia) across the respiratory cycle such that most frequent stimulation onsets occurred during the period of highest heart rate probably indicating highest alertness and cortical excitability. Tactile detection rate was highest during the first quadrant after expiration onset. Interindividually, stronger respiratory phase-locking to the task was associated with higher detection rates. Regarding the cardiac cycle, we confirmed previous findings that tactile detection rate was higher during diastole than systole and newly specified its minimum at 250-300 ms after the R-peak corresponding to the pulse wave arrival in the finger. Expectation of stimulation induced a transient heart deceleration which was more pronounced for unconfident decision ratings. Interindividually, stronger poststimulus modulations of heart rate were linked to higher detection rates. In summary, we demonstrate how tuning to the respiratory cycle and integration of respiratory-cardiac signals are used to optimize performance of a tactile detection task.

Cardiac activity has been shown to interact with conscious tactile perception: Detecting near-threshold tactile stimuli is more likely during diastole than systole and heart slowing is more pronounced for detected compared to undetected stimuli. Here, we investigated how cardiac cycle effects on conscious tactile perception relate to respiration given the natural coupling of these two dominant body rhythms. Forty-one healthy participants had to report conscious perception of weak electrical pulses applied to the left index finger (yes/no) and confidence about their yes/no-decision (unconfident/confident) while electrocardiography (ECG), respiratory activity (chest circumference), and finger pulse oximetry were recorded. We confirmed the previous findings of higher tactile detection rate during diastole and unimodal distribution of hits in diastole, more specifically, we found this only when participants were confident about their detection decision. Lowest tactile detection rate occurred 250-300 ms after the R-peak corresponding to pulse-wave onsets in the finger. Inspiration was locked to tactile stimulation, and this was more consistent in hits than misses. Respiratory cycles accompanying misses were longer as compared to hits and correct rejections. Cardiac cycle effects on conscious tactile perception interact with decision confidence and coincide with pulse-wave arrival, which suggests the involvement of higher cognitive processing in this phenomenon possibly related to predictive coding. The more consistent phase-locking of inspiration with stimulus onsets for hits than misses is in line with previous reports of phase-locked inspiration to cognitive task onsets which were interpreted as tuning the sensory system for incoming information.

Magnetic refrigeration is an upcoming technology that could be an alternative to the more than 100‐year‐old conventional gas–vapor compression cooling. Magnetic refrigeration might answer some of the global challenges linked with the increasing demands for readily available cooling in almost every region of the world and the global‐warming potential of conventional refrigerants. Important issues to be solved are, for example, the required mass and the ecological footprint of the rare‐earth permanent magnets and the magnetocaloric material, which are key parts of the magnetic cooling device. The majority of existing demonstrators use Nd–Fe–B permanent magnets, which account for more than 50% of the ecological footprint, and Gd, which is a critical raw material. This work shows a solution to these problems by demonstrating the world's first magnetocaloric demonstrator that uses recycled Nd–Fe–B magnets as the magnetic field source, and, as a Gd replacement material, La–Fe–Mn–Si for the magnetocaloric heat exchanger. These solutions show that it is possible to reduce the ecological footprint of magnetic cooling devices and provides magnetic cooling as a green solid‐state technology that has the potential to satisfy the rapidly growing global demands.