Optical systems applied for tissue analysis are primarily based on single spectroscopic techniques. This paper however presents a multispectral backscattering sensor designed for in vivo application by a specially formed probe tip which allows side by side monitoring of ultraviolet, visible, near-infrared and fluorescence spectra. The practical applicability of the measurement system was demonstrated in vitro (muscle and adipose tissue) and in vivo in an animal model (mouse). By comparing associated measuring changes in biochemical, physical-morphological and colorimetric values this procedure allows a differentiation between healthy, marginal and malignant tissue.

Abstract. This paper presents an explosion-proof two-channel Raman photometer designed for chemical process monitoring in hazardous explosive atmospheres. Due to its design, alignment of components is simplified and economic in comparison to spectrometer systems. Raman spectrometers have the potential of becoming an increasingly important tool in process analysis technologies as part of molecular-specific concentration monitoring. However, in addition to the required laser power, which restricts use in potentially explosive atmospheres, the financial hurdle is also high. Within the scope of a proof of concept, it is shown that photometric measurements of Raman scattering are possible. The use of highly sensitive detectors allows the required excitation power to be reduced to levels compliant for operation in potentially explosive atmospheres. The addition of an embedded platform enables stable use as a self-sufficient sensor, since it carries out all calculations internally. Multi-pixel photon counters (MPPCs) with large detection areas of 1350 µm2 are implemented as detectors. As a result, the sensitivity of the sensor is strongly increased. This gain in sensitivity is primarily achieved through two characteristics: first, the operating principle “avalanche breakdown” to detect single photons is used; second, the size of the image projected onto the MPPC is much bigger than the pixel area in competing Raman-Spectrometers resulting in higher photon flux. This combination enables reduction of the required excitation power to levels compliant for operation in potentially explosive atmospheres. All presented experiments are performed with strongly attenuated laser power of 35 mW. These include the monitoring of the analytes ethanol and hydrogen peroxide as well as the reversible binding of CO2 to amine. Accordingly, the described embedded sensor is ideally suited as a process analytical technology (PAT) tool for applications in environments with limitations on power input.

This paper provides an overview of how molecule-sensitive, spatially-resolved technologies can be applied for monitoring and measuring in microchannels. The principles of elastic light scattering, fluorescence, near-infrared, mid-infrared, and Raman imaging, as well as combination techniques, are briefly presented, and their advantages and disadvantages are explained. With optical methods, images can be acquired both scanning and simultaneously as a complete image. Scanning technologies require more acquisition time, and fast moving processes are not easily observable. On the other hand, molecular selectivity is very high, especially in Raman and mid-infrared (MIR) scanning. For near-infrared (NIR) images, the entire measuring range can be simultaneously recorded with indium gallium arsenide (InGaAs) cameras. However, in this wavelength range, water is the dominant molecule, so it is sometimes necessary to use complex learning algorithms that increase the preparation effort before the actual measurement. These technologies excite molecular vibrations in a variety of ways, making these methods suitable for specific products. Besides measurements of the fluid composition, technologies for particle detection are of additional importance. With scattered light techniques and evaluation according to the Mie theory, particles in the range of 0.2–1 µm can be detected, and fast growth processes can be observed. Local multispectral measurements can also be carried out with fiber optic-coupled systems through small probe heads of approximately 1 mm diameter.

Technical liquid flow films are the basic arrangement for gas fluid transitions of all kinds and are the basis of many chemical processes, such as columns, evaporators, dryers, and different other kinds of fluid/fluid separation units. This publication presents a new method for molecule sensitive, non-contact, and marker-free localized concentration mapping in vertical falling films. Using Raman spectroscopy, no label or marker is needed for the detection of the local composition in liquid mixtures. In the presented cases, the film mapping of sodium sulfate in water on a plain surface as well as an added artificial streaming disruptor with the shape of a small pyramid is scanned in three dimensions. The results show, as a prove of concept, a clear detectable spectroscopic difference between air, back plate, and sodium sulfate for every local point in all three dimensions. In conclusion, contactless Raman scanning on falling films for liquid mapping is realizable without any mechanical film interaction caused by the measuring probe. Surface gloss or optical reflections from a metallic back plate are suppressed by using only inelastic light scattering and the mathematical removal of background noise.

This is an open access article under the terms of the Creative Commons Attribution-NonCommercial-NoDerivs License, which permits use and distribution in any medium, provided the original work is properly cited, the use is non-commercial and no modifications or adaptations are made.Der Einsatz von faseroptischen Rückstreusensoren zur Inline-Ü berwachung der Partikelkonzentration in hochgefüllten Dispersionen und Lacksystemen wird dargestellt. Durch die Miniaturisierung des Abstandes zwischen Sender-und Empfängerfaser auf < 600 mm kann das eingetragene Licht auch hohe Dispersphasenanteile von bis zu 60 % durchdringen. Aufgrund der Messanordnung finden sich sowohl Transmissions-als auch Streueinflüsse im resultierenden Signal. Es folgt eine mögliche Beschreibung der sich ergebenden nichtlinearen Messkurve mittels eines vereinfachten Modells. Schlagwörter: Faseroptische Rückstreusensoren, Hochgefüllte Dispersionen, Inline-Ü berwachung, PhotometrieThe use of fiber-optic backscattering sensors for inline monitoring of the particle concentration in highly filled dispersions and lacquer systems is shown. Through the miniaturization of the distance between transmitter and detection fiber to < 600 mm, the light can also permeate high disperse phase fractions of up to 60 %. Due to the measurement setup, both transmission and scattering effects can be found in the resulting signal. The possible mathematical description of the resulting nonlinear measured curve using a simplified model follows.