In this paper, the influence of culture conditions (irradiance, temperature, pH, and dissolved oxygen) on the photosynthesis rate of Scenedesmus almeriensis cultures is analyzed. Short-run experiments were performed to study cell response to variations in culture conditions, which take place in changing environments such as outdoor photobioreactors. Experiments were performed by subjecting diluted samples of cells to different levels of irradiance, temperature, pH, and dissolved oxygen concentration. Results demonstrate the existence of photoinhibition phenomena at irradiances higher than 1,000 μE/m(2) s; in addition to reduced photosynthesis rates at inadequate temperatures or pH-the optimal values being 35 °C and 8, respectively. Moreover, photosynthesis rate reduction at dissolved oxygen concentrations above 20 mg/l is demonstrated. Data have been used to develop an integrated model based on considering the simultaneous influence of irradiance, temperature, pH, and dissolved oxygen. The model fits the experimental results in the range of culture conditions tested, and it was validated using data obtained by the simultaneous variation of two of the modified variables. Furthermore, the model fits experimental results obtained from an outdoor culture of S. almeriensis performed in an open raceway reactor. Results demonstrate that photosynthetic efficiency is modified as a function of culture conditions, and can be used to determine the proximity of culture conditions to optimal values. Optimal conditions found (T = 35 °C, pH = 8, dissolved oxygen concentration <20 mg/l) allows to maximize the use of light by the cells. The developed model is a powerful tool for the optimal design and management of microalgae-based processes, especially outdoors, where the cultures are subject to daily culture condition variations.

No abstract

The widespread use of methyl tert-butyl ether (MTBE) as a gasoline additive has resulted in a large number of cases of groundwater contamination. Bioremediation is often proposed as the most promising alternative after treatment. However, MTBE biodegradation appears to be quite different from the biodegradation of usual gasoline contaminants such as benzene, toluene, ethyl benzene and xylene (BTEX). In the present paper, the characteristics of a consortium degrading MTBE in liquid cultures are presented and discussed. MTBE degradation rate was fast and followed zero order kinetics when added at 100 mg l(-1). The residual MTBE concentration in batch degradation experiments ranged from below the detection limit (1 microg l(-1)) to 50 microg l(-1). The specific activity of the consortium ranged from 7 to 52 mgMTBE g(dw)(-1) h(-1) (i.e. 19-141 mgCOD g(dw) (-1) h(-1)). Radioisotope experiments showed that 79% of the carbon-MTBE was converted to carbon-carbon dioxide. The consortium was also capable of degrading a variety of hydrocarbons, including tert-butyl alcohol (TBA), tert-amyl methyl ether (TAME) and gasoline constituents such as benzene, toluene, ethylbenzene and xylene (BTEX). The consortium was also characterized by a very slow growth rate (0.1 d(-1)), a low overall biomass yield (0.11 gdw g(-1)MTBE; i.e. 0.040 gdw gCOD(-1)), a high affinity for MTBE and a low affinity for oxygen, which may be a reason for the slow or absence of MTBE biodegradation in situ. Still, the results presented here show promising perspectives for engineering the in situ bioremediation of MTBE.

The effects of successive mixing (homogenization) of packing material (peat), with or without water addition, on the removal of toluene vapors in a biofilter were studied. Over a period of 50 days, an increase in the Elimination Capacity (EC) of approximately 240% was obtained by successive mixing and water additions. After each mixing, a high EC of toluene was maintained only for a short period of 3–4 days. After this time, decreased biofilter performance was observed, probably associated with the development of dried and/or clogged zones. In the long‐term experiments, an attenuation of the EC recovery was observed after successive mixing. In this case, an increase of 110% over 4 months of experiment was obtained. The global reduction of EC over time could be explained by the colonization of the biofilter by filamentous fungi which was facilitated by the mixing of the packing material. The most frequently observed fungi were identified as Scedosporium sp. and Cladosporium sp. © 2000 John Wiley & Sons, Inc. Biotechnol Bioeng 68: 448–455, 2000.

Biotechnological techniques, including biofilters and biotrickling filters are increasingly used to treat air polluted with VOCs (Volatile Organic Compounds). In this work, the start‐up, the effect of the gaseous ammonia addition on the toluene removal rate, and the problems of the heat accumulation on the performance of a laboratory scale biofilter were studied. The packing material was sterilized peat enriched with a mineral medium and inoculated with an adapted consortium (two yeast and five bacteria). Start‐up showed a short adaptation period and an increased toluene elimination capacity (EC) up to a maximum of 190 g/m3/h. This was related to increased CO2 outlet concentration and temperature gradients between the packed bed and the inlet (Tm‐Tin). These events were associated with the growth of the microbial population. The biofilter EC decreased thereafter, to attain a steady state of 8 g/m3/h. At this point, gaseous ammonia was added. EC increased up to 80 g/m3/h, with simultaneous increases on the CO2 concentration and (Tm‐Tin). Two weeks after the ammonia addition, the new steady state was 30 g/m3/h. In a second ammonia addition, the maximum EC attained was 40 g/m3/h, and the biofilter was in steady state at 25 g/m3/h. Carbon, heat, and water balances were made through 88 d of biofilter operation. Emitted CO2 was about 44.5% of the theoretical value relative to the total toluene oxidation, but accumulated carbon was found as biomass, easily biodegradable material, and carbonates. Heat and water balances showed strong variations depending on EC. For 88 d the total metabolic heat was −181.2 × 103 Kcal/m3, and water evaporation was found to be 56.5 kg/m3. Evidence of nitrogen limitation, drying, and heterogeneities were found in this study. © 1998 John Wiley & Sons, Inc. Biotechnol Bioeng 60: 483–491, 1998.