The question of lateral and/or vertical continuity of subducted slabs in active orogens is a hot topic partly due to poorly resolved tomographic data. The complex slab structure beneath the Alpine region is only partly resolved by available geophysical data, leaving many geological and geodynamical issues widely open. Based upon a finite‐frequency kernel method, we present a new high‐resolution tomography model using P wave data from 527 broadband seismic stations, both from permanent networks and temporary experiments. This model provides an improved image of the slab structure in the Alpine region and fundamental pinpoints for the analysis of Cenozoic magmatism, (U)HP metamorphism, and Alpine topography. Our results document the lateral continuity of the European slab from the Western Alps to the central Alps, and the downdip slab continuity beneath the central Alps, ruling out the hypothesis of slab break off to explain Cenozoic Alpine magmatism. A low‐velocity anomaly is observed in the upper mantle beneath the core of the Western Alps, pointing to dynamic topography effects. A NE dipping Adriatic slab, consistent with Dinaric subduction, is possibly observed beneath the Eastern Alps, whereas the laterally continuous Adriatic slab of the Northern Apennines shows major gaps at the boundary with the Southern Apennines and becomes near vertical in the Alps‐Apennines transition zone. Tear faults accommodating opposite‐dipping subductions during Alpine convergence may represent reactivated lithospheric faults inherited from Tethyan extension. Our results suggest that the interpretations of previous tomography results that include successive slab break offs along the Alpine‐Zagros‐Himalaya orogenic belt might be proficiently reconsidered.

The first discovery of ultrahigh-pressure coesite in the European Alps 30 years ago led to the inference that a positively buoyant continental crust can be subducted to mantle depth; this had been considered impossible since the advent of the plate tectonics concepts. Although continental subduction is now widely accepted, there remains debate because there is little direct (geophysical) evidence of a link between exhumed coesite at the surface and subducted continental crust at depth. Here we provide the first seismic evidence for continental crust at 75 km depth that is clearly connected with the European crust exactly along the transect where coesite was found at the surface. Our data also provide evidence for a thick suture zone with downward-decreasing seismic velocities, demonstrating that the European lower crust underthrusts the Adriatic mantle. These findings, from one of the best-preserved and long-studied ultrahigh-pressure orogens worldwide, shed decisive new light on geodynamic processes along convergent continental margins.*

Since the first discovery of ultrahigh pressure (UHP) rocks 30 years ago in the Western Alps, the mechanisms for exhumation of (U)HP terranes worldwide are still debated. In the western Mediterranean, the presently accepted model of synconvergent exhumation (e.g., the channel-flow model) is in conflict with parts of the geologic record. We synthesize regional geologic data and present alternative exhumation mechanisms that consider the role of divergence within subduction zones. These mechanisms, i.e., (i) the motion of the upper plate away from the trench and (ii) the rollback of the lower plate, are discussed in detail with particular reference to the Cenozoic Adria-Europe plate boundary, and along three different transects (Western Alps, Calabria-Sardinia, and Corsica-Northern Apennines). In the Western Alps, (U)HP rocks were exhumed from the greatest depth at the rear of the accretionary wedge during motion of the upper plate away from the trench. Exhumation was extremely fast, and associated with very low geothermal gradients. In Calabria, HP rocks were exhumed from shallower depths and at lower rates during rollback of the Adriatic plate, with repeated exhumation pulses progressively younging toward the foreland. Both mechanisms were active to create boundary divergence along the Corsica-Northern Apennines transect, where European southeastward subduction was progressively replaced along strike by Adriatic northwestward subduction. The tectonic scenario depicted for the Western Alps trench during Eocene exhumation of (U)HP rocks correlates well with present-day eastern Papua New Guinea, which is presented as a modern analog of the Paleogene Adria-Europe plate boundary.

Detrital geochronology studies require a careful quantification of hydraulic sorting effects, and of the propensity of different parent rocks to yield detrital grains of specific minerals when exposed to erosion (mineral fertility). Because the physical processes of settling and selective entrainment are well known, their effects in sediments can be easily detected and modelled mathematically. By contrast, mineral fertility in parent rocks depends on their full geological history. As a consequence, the relationships between bedrock geology and mineral fertility are hardly predictable, and a direct measurement of this latter parameter is thus required. In this review article, we describe the basic principles of hydraulic sorting, and illustrate a quantitative approach for mineral fertility determination that applies these basic principles to the analysis of modern sediments. Its application to the European Alps shows that apatite and zircon fertility values may range over three orders of magnitude. Variable mineral fertility in parent rocks thus represents, by far, the largest source of bias in detrital geochronology studies. Our study highlights an evident relationship between bedrock geology and mineral fertility, which confirms that the mineral concentration in modern sediments, in the lack of hydraulic sorting effects, is a good proxy of the mineral abundance in bedrock. Mineral fertility maps of the European Alps unravel that metamorphic and plutonic rocks generally have higher apatite and zircon fertility values than sedimentary rocks, but major variations are also observed between different tectonic units within the same paleogeographic domain. The impact of mineral fertility in detrital studies is eventually illustrated with examples from the Alpine region, based on alternative sampling strategies (i.e., the confluence sampling and the along-trunk sampling approaches). We show that geological interpretations are strongly improved when mineral fertility is properly taken into account, not only in modern settings, but also in ancient sedimentary successions.

No abstract