Full–scale dynamic testing of bridge structures can provide valuable information on the service behavior and performance of structures. With the growing interest in the structural condition of highway bridges, dynamic testing can be used as a tool for assessing the integrity of bridges. From the measured dynamic response, induced by instructed passing trucks, modal parameters (natural frequencies, mode shapes and modal damping values) and system parameters (stiffness, mass and damping matrices) are obtained. These identified parameters can then be used to characterize and monitor the service of the bridge structure in the future. Analytical models of the structure can also be validated using these parameters [1,2]. The paper presents a procedure for estimating the traffic load bearing capacity of the steel arch highway viaduct Bridge Structure 205 (DC1–9, 755 m) constructed on Highway D1 in Nord Slovakia (Fig. 1) over the natural hollow basin via dynamic tests of the viaduct structures.

In this paper a dynamic characterization and vibration analysis has been used for the detection and identification of the machine processing condition and the effect of the production machinery vibration on building complex structures and production process. For sensitive process machines and structures dynamic response due to production machinery calculation procedures was applied using experimental input data via spectral analysis. The dynamic analysis of the cutting production machinery with extreme vibration level is described, too.