Research field: close-range photogrammetry, documentation of a cultural heritage using photogrammetric methods, computer vision Address:

Flat slabs are commonly used structures in contemporary architecture. Although their common use there is still problem in design of these structures. The openings adjacent to a column are often used for plumbing and such a position of the openings increases shear stresses in the flat slab near the column. This paper deals with experimental work focused on the punching shear resistance of the flat slab specimens with openings adjacent to column compared to the flat slab specimens without openings. The opening influence is determined experimentally and by using models for the assessment of punching resistance from relevant standards and codes. The material properties of concrete and reinforcing steel were obtained from the laboratory tests.

Wooden trusses are a very specifi c object for measurement. They are often very complex and hard to reach; they are characterized by narrow spaces and low-lighting conditions. In recent years, laser scanning technology was mostly used for this task, because of its contactless nature, the possibility of measurement in the dark, and the robustness of the resulting 3D point clouds. Photogrammetry was mostly used in special cases, e.g., for the measurement of a few selected truss components, but not for the 3D modelling of an entire truss. However, the progress in computer vision algorithms is allowing us to accomplish image-based-modelling on very complex objects. The following contribution compares the point clouds of a wooden truss generated by the leading photogrammetry systems with a point cloud from laser scanning. The results confi rm the interesting potential of actual photogrammetric methods in the modelling of complex objects such as wooden trusses.

Mapping of debris flows by the morphometric analysis of DTM: a case study of the Vrátna dolina Valley, Slovakia The main objective of this contribution is to detect the morphogenetic processes by the numerical method of the differential geometry technique and compare the results with field surveying. The area of interest, the Vrátna dolina Valley, is located in the Malá Fatra Mountains in the northern part of Slovakia. Extensive mass movement deformations occurred in the surveyed area in 2014 induced by extreme precipitation events caused considerable damage. The Proxima software technology has been used to identify terrain elements using a precise digital terrain model (DTM) for the localisation of the debris flows head scarps. Precise DTM was derived from the airborne laser scanning (ALS) data. The morphometric analysis of landslide area was carried out on four selected locations. Verification of numerical mapping was performed by comparing results to the field survey data through visual comparison and area computation. Supplementary data was used in the form of orthophoto mosaics. The used spatial analysis applied on ALS data shows a high coincidence with the detection of the head scarps by field surveying, particularly in the hard to access and afforested areas. The main advantage of this approach lies in the reduction of field surveying and in the possible detection of the terrain changes not found during field surveying.

The use of photogrammetry during load tests of building components is a common