Ivermectin (IVM), a large macrocyclic lactone, specifically enhances P2X(4) receptor-channel function by interacting with residues of transmembrane (TM) helices in the open conformation state. In this paper, we used cysteine-scanning mutagenesis of rat P2X(4)-TMs to identify and map residues of potential importance for channel gating and interaction with IVM. The receptor function was unchanged by mutations in 29 different residues, and among them, the IVM effects were altered in Gln(36), Leu(40), Val(43), Val(47), Trp(50), Asn(338), Gly(342), Leu(346), Ala(349), and Ile(356) mutants. The substitution-sensitive Arg(33) and Cys(353) mutants could also be considered as IVM-sensitive hits. The pattern of these 12 residues was consistent with helical topology of both TMs, with every third or fourth amino acid affected by substitution. These predominantly hydrophobic-nonpolar residues are also present in the IVM-sensitive Schistosoma mansoni P2X subunit. They lie on the same side of their helices and could face lipids in the open conformation state and provide the binding pocket for IVM. In contrast, the IVM-independent hits Met(31), Tyr(42), Gly(45), Val(49), Gly(340), Leu(343), Ala(344), Gly(347), Thr(350), Asp(354), and Val(357) map on the opposite side of their helices, probably facing the pore of receptor or protein and playing important roles in gating.

Abbreviations used: ab-meATP, a,b-methyleneadenosine 5¢-triphoosphate; s off, deactivation time constant; BzATP, 2¢-3¢-O-(4-benzoylbenzoyl)-adenosine 5¢-triphosphate; EC 50, agonist concentration inducing half-maximal effect; EGFP, enhanced green fluorescent protein; HEK293, human embryonic kidney cells; I max, maximum amplitude of current; IVM, ivermectin; P2XR, P2 purinergic receptor channels; WT, wild type. AbstractThe functional relevance of aromatic residues in the upper part of the transmembrane domain-1 of purinergic P2X receptors (P2XRs) was examined. Replacement of the conserved Tyr residue with Ala had a receptor-specific effect: the P2X1R was non-functional, the P2X2R, P2X4R, and P2X3R exhibited enhanced sensitivity to ATP and ab-meATP accompanied by prolonged decay of current after washout of agonists, and the P2X7R sensitivity for agonists was not affected, though decay of current was delayed. The replacement of the P2X4R-Tyr42 with other amino acids revealed the relevance of an aromatic residue at this position. Mutation of the neighboring Phe and ipsilateral Tyr/Trp residues, but not the contralateral Phe residue, also affected the P2X2R, P2X3R, and P2X4R function. Double mutation of ipsilateral Tyr42 and Trp46 P2X4R residues restored receptor function, whereas the corresponding P2X2R double mutant was not functional. In contrast, mutation of the contralateral Phe48 residue in the P2X4R-Y42A mutant had no effect. These results indicate that aromatic residues in the upper part of TM1 play important roles in the three-dimensional structure of the P2XRs and that they are required not only for ion conductivity but also for specificity of agonist binding and/or channel gating.

BackgroundWith the introduction of the first high-throughput qPCR instrument on the market it became possible to perform thousands of reactions in a single run compared to the previous hundreds. In the high-throughput reaction, only limited volumes of highly concentrated cDNA or DNA samples can be added. This necessity can be solved by pre-amplification, which became a part of the high-throughput experimental workflow. Here, we focused our attention on the limits of the specific target pre-amplification reaction and propose the optimal, general setup for gene expression experiment using BioMark instrument (Fluidigm).ResultsFor evaluating different pre-amplification factors following conditions were combined: four human blood samples from healthy donors and five transcripts having high to low expression levels; each cDNA sample was pre-amplified at four cycles (15, 18, 21, and 24) and five concentrations (equivalent to 0.078 ng, 0.32 ng, 1.25 ng, 5 ng, and 20 ng of total RNA). Factors identified as critical for a success of cDNA pre-amplification were cycle of pre-amplification, total RNA concentration, and type of gene. The selected pre-amplification reactions were further tested for optimal Cq distribution in a BioMark Array. The following concentrations combined with pre-amplification cycles were optimal for good quality samples: 20 ng of total RNA with 15 cycles of pre-amplification, 20x and 40x diluted; and 5 ng and 20 ng of total RNA with 18 cycles of pre-amplification, both 20x and 40x diluted.ConclusionsWe set up upper limits for the bulk gene expression experiment using gene expression Dynamic Array and provided an easy-to-obtain tool for measuring of pre-amplification success. We also showed that variability of the pre-amplification, introduced into the experimental workflow of reverse transcription-qPCR, is lower than variability caused by the reverse transcription step.Electronic supplementary materialThe online version of this article (doi:10.1186/s12867-015-0033-9) contains supplementary material, which is available to authorized users.