No abstract

In a cell-free (CF) massive MIMO architecture a very large number of distributed access points (APs) simultaneously and jointly serves a much smaller number of mobile stations (MSs); a variant of the cellfree technique is the user-centric (UC) approach, wherein each AP just decodes a reduced set of MSs, practically the ones that are received best. This paper introduces and analyzes the CF and UC architectures at millimeter wave (mmWave) frequencies. First of all, a multiuser clustered channel model is introduced in order to account for the correlation among the channels of nearby users; then, an uplink multiuser channel estimation scheme is described along with low-complexity hybrid analog/digital beamforming architectures. Interestingly, in the proposed scheme no channel estimation is needed at the MSs, and the beamforming schemes used at the MSs are channelindependent and have a very simple structure. Numerical results show that the considered architectures provide good performance, especially in lightly loaded systems, with the UC approach outperforming the CF one.

Factory automation is one of the use cases for 5G-and-beyond mobile networks where strict requirements in terms of latency, availability and reliability are required. In this paper, we investigate the potentials of massive MIMO in delivering those promises for industrial automation. Namely, communications between actuators (ACs) and Access Points (APs) inside an industrial scenario is considered and different transmission modes are compared: joint transmission (JT) where the distributed antennas are used to communicate with each AC, cell-free transmission (CFT) where all the ACs are served by all APs, single AP transmission (SAT) where each AC is served by only one AP, and user-centric transmission (UCT) where each AC is served by a subset of APs. A power control strategy, aimed at maximizing the minimum signal-to-interference plus noise ratio (SINR), is also introduced. Numerical results, shown in terms of downlink SINR and achievable rate, evaluated using the final block length capacity formula (FBLC), demonstrate that the use of distributed antenna setting and of power control bring substantial performance improvements in terms of reliability and latency.