Infectious diseases and underlying medical conditions common to Africa may affect influenza frequency and severity. We conducted a systematic review of published studies on influenza and the following co-infections or co-morbidities that are prevalent in Africa: dengue, malaria, measles, meningococcus, Pneumocystis jirovecii pneumonia (PCP), hemoglobinopathies, and malnutrition. Articles were identified except for influenza and PCP. Very few studies were from Africa. Sickle cell disease, dengue, and measles co-infection were found to increase the severity of influenza disease, though this is based on few studies of dengue and measles and the measles study was of low quality. The frequency of influenza was increased among patients with sickle cell disease. Influenza infection increased the frequency of meningococcal disease. Studies on malaria and malnutrition found mixed results. Age-adjusted morbidity and mortality from influenza may be more common in Africa because infections and diseases common in the region lead to more severe outcomes and increase the influenza burden. However, gaps exist in our knowledge about these interactions.

No abstract

Diesel engines serve many purposes in modern oil and gas extraction activities. Diesel particulate matter (DPM) emitted from diesel engines is a complex aerosol that may cause adverse health effects depending on exposure dose and duration. This study reports on personal breathing zone (PBZ) and area measurements for DPM (expressed as elemental carbon) during oil and gas extraction operations including drilling, completions (which includes hydraulic fracturing) and servicing work. Researchers at the National Institute for Occupational Safety and Health (NIOSH) collected 104 full-shift air samples (49 PBZ and 55 area) in Colorado, North Dakota, Texas, and New Mexico during a four year period from 2008-2012 The arithmetic mean (AM) of the full shift TWA PBZ samples was 10 μg/m3; measurements ranged from 0.1 to 52 μg/m3. The geometric mean (GM) for the PBZ samples was 7 μg/m3. The AM of the TWA area measurements was 17 μg/m3 and ranged from 0.1 to 68 μg/m3. The GM for the area measurements was 9.5 μg/m3. Differences between the GMs of the PBZ samples and area samples were not statistically different (P>0.05). Neither the Occupational Safety and Health Administration (OSHA), NIOSH, nor the American Conference of Governmental Industrial Hygienists (ACGIH) have established occupational exposure limits (OEL) for DPM. However, the State of California, Department of Health Services lists a time-weighted average (TWA) OEL for DPM as elemental carbon (EC) exposure of 20 μg/m3. Five of 49 (10.2%) PBZ TWA measurements exceeded the 20 μg/m3 EC criterion. These measurements were collected on Sandmover and Transfer Belt (T-belt) Operators, Blender and Chemical Truck Operators, and Water Transfer Operators during hydraulic fracturing operations. Recommendations to minimize DPM exposures include elimination (locating diesel-driven pumps away from well sites), substitution, (use of alternative fuels), engineering controls using advanced emissions controls technologies, administrative controls (configuration of well sites), hazard communication and worker training.