A calibration procedure for the detection efficiency of energy dispersive X-ray spectrometers (EDS) used in combination with scanning electron microscopy (SEM) for standardless electron probe microanalysis (EPMA) is presented. The procedure is based on the comparison of X-ray spectra from a reference material (RM) measured with the EDS to be calibrated and a reference EDS. The RM is certified by the line intensities in the X-ray spectrum recorded with a reference EDS and by its composition. The calibration of the reference EDS is performed using synchrotron radiation at the radiometry laboratory of the Physikalisch-Technische Bundesanstalt. Measurement of RM spectra and comparison of the specified line intensities enables a rapid efficiency calibration on most SEMs. The article reports on studies to prepare such a RM and on EDS calibration and proposes a methodology that could be implemented in current spectrometer software to enable the calibration with a minimum of operator assistance.

In order to maintain the thermo-mechanical durability of ITER it is proposed to castellate the interior surface of the first wall and divertor by splitting them into small-size cells [W. Daener et al., Fusion Eng. Des. 61&62 (2002) 61]. A concern is the accumulation of fuel in the gaps of the castellation. In TEXTOR, molybdenum limiters were exposed in the scrape-off layer (SOL) plasma to assess fuel accumulation. The first limiter was exposed under deposition-dominated conditions. Carbon deposits were formed both on top surfaces and in the gaps. About 0.12% of the impinging D-fluence was found in the gaps. Another castellated limiter was exposed under erosion-dominated conditions. Deposited layers were found only on the plasma shadowed areas of the gaps. A significant amount of molybdenum from the limiter was found intermixed in the deposit. The gaps contained $0.03% of the impinging D-fluence. Modeling was performed to simulate carbon transport into the gaps.