Digital printing enables solution processing of functional materials and opens a new route to fabricate low-cost electronic devices. One crucial parameter that affects the wettability of inks for all printing techniques is the surface free energy (SFE) of the substrate. Siloxanes, with their huge variety of side chains and their ability to form self-assembled monolayers, offer exhaustive control of the substrate SFE from hydrophilic to hydrophobic. Thus, siloxane treatment is a suitable approach to adjust the substrate conditions to the desired ink, instead of optimizing the ink to an arbitrary substrate. In this work, the influence of different fluorinated and nonfluorinated siloxanes on the SFE of different substrates, such as polymers, glasses, and metals, are examined. By mixing several siloxanes, we demonstrate the fine tuning of the surface energy. The polar and dispersive components of the SFE are determined by the Owens-Wendt-Rabel-Kaelble (OWRK) method. Furthermore, the impact of the siloxanes and therefore the SFE on the pinning of droplets and wet films are assessed via dynamic contact angle measurements. SFE-optimized substrates enable tailoring the resolution of inkjet printed silver structures. A nanoparticulate silver ink was used for printing single drops, lines, and source-drain electrodes for transistors. These were examined in terms of diameter, edge quality, and functionality. We show that by adjusting the SFE of an arbitrary substrate, the printed resolution is substantially increased by minimizing the printed drop size by up to 70%.

Low temperature NiOx is achieved using PEO as sacrificial ink additive to make hole transport layer for solar cells.

A problem of bulk-heterojunction (BHJ) organic photodetectors (OPDs) is the morphological instability arising from segregation and demixing of its donor and acceptor components. To stabilize the morphology of the blended active layer we synthesized a cross-linkable low-band-gap 1,4-diketopyrrolo[3,4-c]pyrrole (DPP)-based donor−acceptor (DA) copolymer with ω-alkenyl side chains. Due to its absorption cutoff above 1000 nm we employed it as an acceptor material in a solution-processed BHJ nearinfrared-OPD with P3HT as a donor. Photochemical in situ thiol−ene click chemistry using a tetrathiol as an additive cross-linker renders the BHJ insoluble to organic solvents and stable under accelerated thermal aging.

No abstract

Organic photodiodes (OPDs) are optical sensors combining high performance, lightweight mechanical flexibility, and processability from solution. Their fabrication by industrial printing techniques opens a wide range of innovative applications for emerging fields in sensing and the Internet of Things. They typically consist of printed multilayers with functionalities to absorb light, to extract charges, or to reduce detection noise. However, the printing of such device architecture poses a challenge as the deposition of a material can lead to disruption of film morphology or intermixing of materials if its solvent interacts with the previously deposited layer. This work proposes a process to print multilayers from the same solvent system utilizing the aerosol‐jet technique. By fine adjustment of the aerosol properties through the tube temperature (TTube), the drying time of poly(3‐hexylthiophene‐2,5‐diyl) (P3HT) printed layers is significantly reduced. This allows its deposition onto a P3HT‐based bulk‐heterojunction (BHJ) without negatively affecting its performance. The additional printed P3HT layer, spatially extends the donor region of the BHJ, providing ideal hole extraction and simultaneous noise reduction by the blocking of injected electrons. This donor blocking layer (DBL) yields a noise reduction of two orders of magnitude in OPDs operated under −2 V reverse bias.