No abstract

There is a considerable practical interest in discovering new ways to obtain organomolybdenum heterogeneous catalysts for olefin epoxidation that are easier to recover and reuse and display enhanced productivity. In this study, the complex salt (H2pytz)[MoO2Cl2(pytz)] (1) (Hpytz = 5-(2-pyridyl)tetrazole) has been prepared, structurally characterized, and employed as a precursor for the hydrolysis-based synthesis of a microcrystalline molybdenum oxide/organic hybrid material formulated as [MoO3(Hpytz)] (2). In addition to single-crystal X-ray diffraction (for 1), compounds 1 and 2 were characterized by FT-IR and Raman spectroscopies, solid-state 13C{1H} cross-polarization (CP) magic-angle spinning (MAS) NMR, and scanning electron microscopy (SEM). Compounds 1 and 2 were evaluated as olefin epoxidation catalysts using the model reaction of cis-cyclooctene (Cy8) with tert-butyl hydroperoxide (TBHP), at 70 °C, which gave 100% epoxide selectivity up to 100% conversion. While 1 behaved as a homogeneous catalyst, hybrid 2 behaved as a heterogeneous catalyst and could be recovered for recycling without showing structural degradation or loss of catalytic performance over consecutive reaction cycles. The substrate scope was broadened to monoterpene DL-limonene (Lim) and biobased unsaturated fatty acid methyl esters, methyl oleate (MeOle), and methyl linoleate (MeLin), which gave predominantly epoxide products.

The discovery of heterogeneous catalysts synthesized in easy, sustainable ways for the valorization of olefins derived from renewable biomass is attractive from environmental, sustainability, and economic viewpoints. Here, an organic–inorganic hybrid catalyst formulated as [MoO3(Hpto)]·H2O (2), where Hpto = 5-(2-pyridyl-1-oxide)tetrazole, was prepared by a hydrolysis–condensation reaction of the complex [MoO2Cl2(Hpto)]∙THF (1). The characterization of 1 and 2 by FT-IR and Raman spectroscopies, as well as 13C solid-state NMR, suggests that the bidentate N,O-coordination of Hpto in 1 (forming a six-membered chelate ring, confirmed by X-ray crystallography) is maintained in 2, with the ligand coordinated to a molybdenum oxide substructure. Catalytic studies suggested that 2 is a rare case of a molybdenum oxide/organic hybrid that acts as a stable solid catalyst for olefin epoxidation with tert-butyl hydroperoxide. The catalyst was effective for converting biobased olefins, namely fatty acid methyl esters (methyl oleate, methyl linoleate, methyl linolenate, and methyl ricinoleate) and the terpene limonene, leading predominantly to the corresponding epoxide products with yields in the range of 85–100% after 24 h at 70 °C. The versatility of catalyst 2 was shown by its effectiveness for the oxidation of sulfides into sulfoxides and sulfones, at 35 °C (quantitative yield of sulfoxide plus sulfone, at 24 h; sulfone yields in the range of 77–86%). To the best of our knowledge, 2 is the first molybdenum catalyst reported for methyl linolenate epoxidation, and the first of the family [MoO3(L)x] studied for methyl ricinoleate epoxidation.

No abstract