No abstract

No abstract

In recent years, the application of solid foams has become widespread. Solid foams are not only used in the aerospace field but also in everyday life. Although foams are promising dosage forms in the pharmaceutical industry, their usage is not prevalent due to decreased stability of the solid foam structure. These special dosage forms can result in increased bioavailability of drugs. Low-density floating formulations can also increase the gastric residence time of drugs; therefore, drug release will be sustained. Our aim was to produce a stable floating formula by foaming. Matrix components, PEG 4000 and stearic acid type 50, were selected with the criteria of low gastric irritation, a melting range below 70 °C, and well-known use in oral drug formulations. This matrix was melted at 54 °C in order to produce a dispersion of active substance and was foamed by different gases at atmospheric pressure using an ultrasonic homogenizer. The density of the molded solid foam was studied by the pycnometer method, and its structure was investigated by SEM and micro-CT. The prolonged drug release and mucoadhesive properties were proved in a pH 1.2 buffer. According to our experiments, a stable foam could be produced by rapid homogenization (less than 1 min) without any surfactant material.

Cu/AlN–Al2O3 nano-multilayer (NML) was deposited by magnetron sputtering method on 42CrMo4 steel samples, starting with a 15 nm AlN–Al2O3 layer and followed by 200 alternating layers of 5 nm thick Cu and 5 nm thick AlN–Al2O3 layers. The microstructure and thermal behaviour of the as-deposited and heat-treated multilayer was studied. Starting from about 400 °C, extensive coarsening of Cu nanocrystallites and the migration of Cu within the multilayer were observed via solid-state diffusion. Part of the initial Cu even formed micron-sized reservoirs within the NML. Due to increased temperature and to the different heat expansion coefficients of Cu and the AlN–Al2O3, the latter cracked and Cu appeared on the top surface of the NML at around 250 °C. Below 900 °C, the transport of Cu to the top surface of the NML probably took place as a solid-state flow, leading to faceted copper micro-crystals. However, above 900 °C, the Cu micro-crystals found on the top of the NML have rounded shape, so they were probably formed by pre-melting of nano-layered Cu due to its high specific surface area in the NML. Even if the Cu crystals appear on the top surface of the NML via solid-state flow without pre-melting, the Cu crystals on the top surface of the NML can be potentially used in joining applications at and above 250 °C.

In this study electroless NiP coatings were deposited on W302 steel substrates. The effects of bath pH and heat treatment at 400 °C were investigated on the surface morphology, phase structure, phosphorus content, thickness and microhardness of the coatings. It was observed that both the phosphorus content and coating thickness are dependent on the bath pH. In an acidic/neutral bath, low and medium phosphorus coatings with thickness of 13.9-19.8 μm were synthesized, while in an alkaline bath, high phosphorus, 4.8-5.8 μm-thick coatings were formed. Coatings containing medium or high P seemed to be amorphous, while low P coatings had microcrystalline structures. Hardness was also dependent on the composition of the coating. After heat treatment, the structure of the coatings transformed into crystalline Ni with the precipitation of Ni 3 P phases, which resulted further increases in hardness.