The choice between different surgical options depends on bone defect dimension and characteristics but are also patient-related. Reestablishment of well-aligned and stable implants is necessary for successful reconstruction, but this can't be accomplished without a sufficient restoration of an eventual bone loss.

Various short hip stems have been introduced with differing implant concepts of femoral fixation and implant length. There is a lack of proper classification for short hip stems, with a clear and accepted definition for implant length and extent of bone preservation in the metaphyseal and diaphyseal femur. This study analyzed the length of short hip stems. Stems were divided into collum, partial collum, and trochanter-sparing implants. An additional category was added, trochanter harming, which was defined as interruption of the circumferential integrity of the femoral neck. For all of the femoral components described, the designs were compared, excluding stems with insufficient clinical data. The 15 finally selected stems were classified as collum (1 stem), partial collum (7 stems), trochanter sparing (4 stems), and trochanter harming (3 stems). Mid-term results (>5 years of follow-up) were available for only 3 designs in the partial collum group. Taking into account the results of short-term studies (<5 years of follow-up), the femoral revision rate per 100 observed component years was <1 for most total hip arthroplasties. However, the studies varied greatly regarding level of significance, and short hip stems without published results are available commercially. Short hip stems cannot be circumscribed by a simple length limit. For some designs, clinical data collected from large patient cohorts showed a survivorship comparable to traditional stems. In cases that must be revised, this often can be performed with a conventional primary stem, fulfilling the promise to preserve bone for potential future revisions in younger patients.

Hip dislocation is a major and common complication of total hip arthroplasty (THA), which appears with an incidence between 0.3% and 10% in primary total hip arthroplasties and up to 28% in revision THA. The hip dislocations can be classified into three groups: early, intermediate and late. Approximately two-thirds of cases can be treated successfully with a non-operative approach. The rest require further surgical intervention. The prerequisite to developing an appropriate treatment strategy is a thorough evaluation to identify the causes of the dislocation. In addition, many factors that contribute to THA dislocation are related to the surgical technique, mainly including component orientation, femoral head diameter, restoration of femoral offset and leg length, cam impingement and condition of the soft tissues. The diagnosis of a dislocated hip is relatively easy because the clinical situation is very typical. Having identified a dislocated hip, the first step is to perform a closed reduction of the implant. After reduction you must perform a computed tomography scan to evaluate the surgical options for treatment of recurrent dislocation that include: revision arthroplasty, modular components exchange, dual-mobility cups, large femoral heads, constrained cups, elimination of impingement and soft tissue procedures. The objective is to avoid further dislocation, a devastating event which is increasing the number of operations on the hip. To obtain this goal is useful to follow an algorithm of treatment, but the best treatment remains prevention.

The MIPO technique for proximal humeral fractures was safe and reproducible for most common patterns of fracture. Major complication rate was apparently low due to a soft tissue sparing, deltoid muscle and circumflex vessels, with easy access of the bar area to correct positioning of the plate.

Osteoporotic proximal humerus fractures may present an important impaction and loss of reduction in the first 3 months after surgery even if treated with a rigid device and multiple head screws. Surgeons treating these osteoporotic fractures should be aware of these complications even when using a rigid device.