Abstract:In this paper a system of a grid side and a generator side converters, both working with a common capacitor, is presented. The 6-phase asymmetric inset-type SMPMSM generator is used. A large pole pair number of this generator enables a gearless wind turbine operation. The fundamental and 3rd harmonic cooperation is used to increase the generator performance. This is accomplished by means of the 3rd harmonic current injection. For that reason the generator side converter must have a neutral connection.

No abstract

In einem gemeinsamen Projekt der Firmen Stumer, Avibia und Iotech wurde eine intelligente Dampfdruck‐Reduzierstation als Package Unit entwickelt, die hierbei abfallende Energie ins Stromnetz speist und sich dank einer standardisierten MTP‐Schnittstelle mit geringem Integrationsaufwand nachrüsten lässt.

No abstract

Purpose Due to the installation of the new, more powerful gearbox and the dismantling of the exciter machine, the vibration characteristics of the shaft train will be changed. Therefore, it is necessary to reassess the shaft train. It is to be investigated if the shaft train of the compressor meets the general requirements for bending and torsional vibrations and can be safely operated within the electrical network. The purpose of this paper is to show the necessary alignment of modification, calculation and measurement in such a project.. Design/methodology/approach After some modification work on the shaft train of an air compressor, it was necessary to do some engineering calculations regarding the bending natural and torsional natural frequencies and their mode shapes. The correctness of the calculated values was proven by vibration measurements performed at the shaft train in operation. Findings It can be concluded that the change and replacement of rotating equipment in a shaft train never should be done without any engineering calculations in advance and measurements after the component modification. Most important is that the calculation results have to be compared with the measurement results for verifying the calculation assumptions. In the case described above, one can see that theory and practice match well. In addition to this, the very low damping of torsional vibrations is proved again, which can be a significant problem in some situations. Originality/value Also, today one can find torsional vibration measurements of rotating machines, including frequency, magnitude and damping factor, very seldom. Especially for smaller machines, there are no real comparisons between calculation and measurement are usual. This paper shows that an alignment between theoretical and practical approaches is necessary to avoid operational problems for rotating machines.