Piezoelectric inertia motors-also known as stick-slip motors or (smooth) impact drives-use the inertia of a body to drive it in small steps by means of an uninterrupted friction contact. In addition to the typical advantages of piezoelectric motors, they are especially suited for miniaturisation due to their simple structure and inherent fine-positioning capability. Originally developed for positioning in microscopy in the 1980s, they have nowadays also found application in mass-produced consumer goods. Recent research results are likely to enable more applications of piezoelectric inertia motors in the future. This contribution gives a critical overview of their historical development, functional principles, and related terminology. The most relevant aspects regarding their design-i.e., friction contact, solid state actuator, and electrical excitation-are discussed, including aspects of control and simulation. The article closes with an outlook on possible future developments and research perspectives.

A piezoelectric energy harvester is an electromechanical device that converts ambient mechanical vibration into electric power. Most existing vibration energy harvesting devices operate effectively at a single frequency only, dictated by the design of the device. This frequency must match the frequency of the host structure vibration. However, real world structural vibrations rarely have a specific constant frequency. Therefore, piezoelectric harvesters that generate usable power across a range of exciting frequencies are required to make this technology commercially viable. Currently known harvester tuning techniques have many limitations, in particular they miss the ability to work during harvester operation and most often cannot perform a precise tuning. This paper describes the design and testing of a vibration energy harvester with tunable resonance frequency, wherein the tuning is accomplished by changing the attraction force between two permanent magnets by adjusting the distance between the magnets. This tuning technique allows the natural frequency to be manipulated before and during operation of the harvester. Furthermore the paper presents a physical description of the frequency tuning effect. The experimental results achieved with a piezoelectric bimorph fit the calculated results very well. The calculation and experimental results show that using this tuning technique the natural frequency of the harvester can be varied efficiently within a wide range: in the test setup, the natural frequency of the piezoelectric bimorph could be increased by more than 70%.

No abstract

No abstract

No abstract