Thermo-luminescent detectors are currently used to measure gamma doses in the medical and environmental surveillance fields. During the past few years, the CEA Reactor Studies Division tested and validated the use of these detectors for gamma flux characterization and nuclear heating measurements in mixed neutron/gamma fields of low power reactors. Doses were comprised between a few mGy and a few Gy for dose rates up to a few Gy.h-1. However, in MTR or TRIGA reactors, the gamma flux level is much higher (> 1012 n/cm2/s) and the TLD currently in use (CaF2:Mn and 7LiF:Mg,Ti) and their readout protocols were no longer suitable for the resulting doses. In order to extend the applicable dose range up to ∼1 MGy (dose rate of a few kGy.h-1), several options were explored. On one side, some adjustments were made to the readout protocols of CaF2:Mn and 7LiF:Mg,Ti, notably by testing the use of filters to reduce the amount of light received by the reader PMT to avoid saturation. On the other side, a new type of TLD (LiF:Mg,Cu,P) with different Li enrichments (natural or enriched in 7Li) was tested. This paper presents the calibration measurements results performed in pure gamma fields, at the irradiation platform of the CEA Cadarache Radioprotection Division, between 250 mGy and 3 Gy for all detector types. In addition to the calibration, these measurements also studied the Mg,Cu,P-doped detectors response: reproducibility, dose rate dependence, incoming photon energy dependence, high temperature effect when reading TLD, etc. Results show that at low doses Mg,Cu,P-doped TLDs are slightly less stable than CaF2:Mn and 7LiF:Mg,Ti. The sensitivity modification after a high dose exposure seems to indicate that a new protocol readout should be defined for Mg,Cu,P-doped sensors (high temperature peak).

The study of nuclear fission yields has a major impact on the characterization and understanding of the fission process and is mandatory for reactor applications. In the framework of a collaboration between the CEA, the LPSC and the ILL, a program of actinide fission yield measurements has been ongoing for several years at the LOHENGRIN spectrometer. However, the measurement of very low fission yields in the symmetry region and the heavy wing of the distributions is difficult to achieve due to the strong contamination by other masses with much higher yields and requires the development of a new experimental setup. This paper will first present the results of a new absolute measurement of the 235U(nth,f) mass yields using an ionization chamber placed at the exit of the spectrometer. Although very well documented in the literature, these yields show uncertainties lying from 3% to 10% with large discrepancies between libraries and a lack of correlation matrices. New experimental data obtained at the LOHENGRIN spectrometer will be detailed, along with the measurement method and the production of the experimental covariance matrix. The second part will show the development of a Time of Flight (ToF) line in order to improve the background rejection in the mass yield measurements. In the symmetry region, the precision of the measurement is limited by the background estimation due to the charge exchanges with the residual gas of the separator. We plan to analyze the events using a triple coincidence (∆E x E) x ToF, whereas today only (∆E x E) selection is available. The new ToF line is built using Si3N4 foils and secondary electron detectors (SED) for the start and stop detectors. We will present the choices made for the SED technology along with the progress achieved on the ToF line characterization.