No abstract

Laser Powder Bed Fusion (LPBF) is a widely used additive manufacturing technique for powder-based polymers and metallic materials. Thermoplastics like Polyamide 12 and Polyamide 6 are commonly used in LPBF; thermosetting polymers are gaining attention due to their superior stability. Epoxies are a popular thermoset, but some exhibit low physical properties and brittleness, leading to reduced toughness. The work presented in this paper explores the effect of using short carbon fibers (CF) as additives to epoxy-based thermosetting material on physical and thermomechanical properties. A total of six epoxy thermoset/CF composite powder blends were prepared by varying reinforcing materials weight percentages (0 wt%, 0.3 wt%, 0.6 wt%, 1 wt%, 5 wt%, and 10 wt%). Tensile, four-point bending, and dynamic mechanical analysis (DMA) test samples were printed using the LPBF technique. Significant improvements in the physical and thermomechanical properties were obtained in the thermoset composites with 5 wt% of CF due to good adhesion between reinforcing materials and the matrix and a low level of porosity. Fracture surface analysis was performed via scanning electron microscopy (SEM), which provided insight into the influence of CF on the properties of thermosetting composites. The findings of this research demonstrate the feasibility of improving the inferior physical and thermomechanical properties of 3D-printed CF-reinforced epoxy. With a certain amount of CF reinforcement, Young’s modulus and fracture modulus can be increased by around 52% and 259%, respectively.

The ever-changing nature of the power industry will require the implementation of hybrid energy systems. Integration of tightly coupled components in hybrids often involves the diversion of exhaust gas flow. An innovative smart material actuation technology is proposed to replace traditional electro-mechanical actuated valve mechanisms with lighter and less expensive actuators. A shape memory alloy (SMA) spring-actuated valve was designed for high-temperature service to demonstrate the promise of smart materials in control valve applications. With SMA springs only generating a maximum force of 3.2 N, an innovative valve design was necessary. To demonstrate the concept, a 3-inch Nominal Pipe Size valve was designed, and 3D printed using the stereolithography technique. Increasing the electrical current to actuate the SMA springs reduced actuation time. The maximum current of 10 A produced the lowest actuation time of 2.85 s, with an observed maximum stroke rate of more than 100 stroke completion %/s (considering actuation open/close as 100% stroke) at the midrange. The final assembly of the valve was estimated to provide a cost reduction of more than 30% and a weight reduction of more than 80% compared to the other available automatic valves in the present market.

The ever-changing nature of the power industry will require the implementation of hybrid energy systems. Integration of tightly coupled components in hybrids often involves the diversion of high-temperature flow, which need expensive valve technology. An innovative smart material actuation technology is proposed to replace traditional electro-mechanical actuated valve mechanisms with lighter and less expensive actuators. A shape memory alloy (SMA) spring-actuated valve was designed for high-temperature service to demonstrate the promise of smart materials in control valve applications. With SMA springs only generating a maximum force of 3.2N, an innovative valve design was necessary. To demonstrate the concept, a 3-inch Nominal Pipe Size valve was designed and 3D printed using the Stereolithography technique. Increasing the electrical current to actuate the SMA springs reduced actuation time. The maximum current of 10 amps produced the lowest actuation time of 2.85 seconds, with an observed maximum stroke rate of more than 100%/s (considering actuation open/close as 100% stroke) at the midrange. The final assembly of the valve for high-temperature (>600°C) applications was estimated to provide a cost reduction of more than 75% and a weight reduction of 90%.