Seed germination and plant stand is a major problem in cotton especially

Background: Green gram is a popular pulse crop in India (with 2.02 MT production over a cultivated area of 4.26 Mha) and Odisha (20.8 lakh ha area with a yield of 10.60 lakh tonnes). The information on the engineering properties and its behavioural changes with moisture content is vital for handling and designing of different agricultural processing equipment. Methods: This work mainly focused on studying green gram variety’s (Sujata) engineering properties at five different moisture levels (within a moisture range of 10.58 to 45.45% (d.b.). Standard methods and procedures were followed in the study and the output results were compared with previous research work to justify the variation or anomaly in some cases. The curve estimation method (regression analysis) was followed to find the best-fit curve and equation for the parameters studied. Result: The geometric mean diameter (GMD) of grain increased from 3.75 to 4.12 mm within the moisture content (MC) range and the variation was statistically significant (p less than 0.05). Sphericity and surface area varied significantly from 0.83 to 0.82 and 44.13 to 53.45 mm2, respectively, within the range of moisture contents studied with a high correlation among the data. Mass of thousand grains augmented (44.13 to 53.45 g) with a rise in MC and the data followed logarithmic and inverse curves. Bulk and true densities of green gram declined significantly from 860 to 670 kg m-3 and 1330 to 1240 kg m-3 with an increase in the moisture content. The porosity of green gram increased significantly from 35.75% to 46.38% and the terminal velocity raised from 9.20 m s-1 to 11.10 m s-1 with an increase in MC. The dynamic angle of repose increased significantly from 30.95 to 46.57o with MC. A significant variation in the coefficient of internal friction (0.78 to 0.90) was observed for the grains. The coefficient of static friction of grain increased significantly for different surfaces (MS, SS, Plywood and GI) with a rise in MC. The MS surface produced the highest coefficient of static friction and SS had the least. The results confirmed significant effect of MC on all engineering properties of green gram.