Template polymerization of a high internal phase emulsion (polyHIPE) is a relatively new method to produce tunable high-porosity scaffolds for tissue regeneration. This study focuses on the development of biodegradable injectable polyHIPEs with interconnected porosity that have the potential to fill bone defects and enhance healing. Our laboratory previously fabricated biodegradable polyHIPEs that cure in situ upon injection; however, these scaffolds possessed a closed-pore morphology, which could limit bone ingrowth. To address this issue, HIPEs were fabricated with a radical initiator dissolved in the organic phase rather than the aqueous phase of the emulsion. Organic-phase initiation resulted in macromer densification forces that facilitated pore opening during cure. Compressive modulus and strength of the polyHIPEs were found to increase over 2 weeks to 43 -12 MPa and 3 -0.2 MPa, respectively, properties comparable to cancellous bone. The viscosity of the HIPE before cure (11.0 -2.3 Pa$s) allowed for injection and filling of the bone defect, retention at the defect site during cure under water, and microscale integration of the graft with the bone. Precuring the materials before injection allowed for tuning of the work and set times. Furthermore, storage of the HIPEs before cure for 1 week at 4°C had a negligible effect on pore architecture after injection and cure. These findings indicate the potential of these emulsions to be stored at reduced temperatures and thawed in the surgical suite before injection. Overall, this work highlights the potential of interconnected propylene fumarate dimethacrylate polyHIPEs as injectable scaffolds for bone tissue engineering.

Polymerized high internal phase emulsions (polyHIPEs) have been utilized in the creation of injectable scaffolds that cure in situ to fill irregular bone defects and potentially improve tissue healing. Previously, thermally initiated scaffolds required hours to cure, which diminished the potential for clinical translation. Here, a double-barrel syringe system for fabricating redox-initiated polyHIPEs with dramatically shortened cure times upon injection was demonstrated with three methacrylated macromers. The polyHIPE cure time, compressive properties, and pore architecture were investigated with respect to redox initiator chemistry and concentration. Increased concentrations of redox initiators reduced cure times from hours to minutes and increased the compressive modulus and strength without compromising the pore architecture. Additionally, storage of the uncured emulsion at reduced temperatures for 6 months was shown to have minimal effects on the resulting graft properties. These studies indicate that the uncured emulsions can be stored in the clinic until they are needed and then rapidly cured after injection to rigid, high-porosity scaffolds. In summary, we have improved upon current methods of generating injectable polyHIPE grafts to meet translational design goals of long storage times and rapid curing (<15 min) without sacrificing porosity or mechanical properties.

Polymerized high internal phase emulsions (polyHIPEs) are highly porous constructs currently under investigation as tissue engineered scaffolds. We previously reported on the potential of redox-initiated polyHIPEs as injectable bone grafts that space fill irregular defects with improved integration and rapid cure. Upon subsequent investigation, the radical-initiated cure of these systems rendered them susceptible to oxygen inhibition with an associated increase in uncured macromer in the clinical setting. In the current study, polyHIPEs with increased resistance to oxygen inhibition were fabricated utilizing a tetrafunctional thiol, pentaerythritol tetrakis(3-mercaptoproprionate), and the biodegradable macromer, propylene fumarate dimethacrylate. Increased concentrations of the tetrathiol additive provided improved oxygen resistance as confirmed by polyHIPE gel fraction while retaining the requisite rapid cure rate, compressive properties, and pore architecture for use as an injectable bone graft. Additionally, thiol-methacrylate polyHIPEs exhibited increased degradation under accelerated conditions and supported critical markers of human mesenchymal stem cell activity. In summary, we have improved upon current methods of fabricating injectable polyHIPE grafts to meet translational design goals of improved polymerization kinetics under clinically relevant conditions without sacrificing key scaffold properties.