We present an experiment-based characterization of passive suppression and active self-interference cancellation mechanisms in full-duplex wireless communication systems. In particular, we consider passive suppression due to antenna separation at the same node, and active cancellation in analog and/or digital domain. First, we show that the average amount of cancellation increases for active cancellation techniques as the received self-interference power increases. Our characterization of the average cancellation as a function of the self-interference power allows us to show that for a constant signal-to-interference ratio at the receiver antenna (before any active cancellation is applied), the rate of a full-duplex link increases as the self-interference power increases. Second, we show that applying digital cancellation after analog cancellation can sometimes increase the self-interference, and thus digital cancellation is more effective when applied selectively based on measured suppression values. Third, we complete our study of the impact of self-interference cancellation mechanisms by characterizing the probability distribution of the self-interference channel before and after cancellation. I. INTRODUCTIONCurrent deployed wireless communication systems employ either a time-division or frequencydivision approach to bidirectional communication. This requires dividing the temporal and/or spectral resources into orthogonal resources and results in half-duplex wireless communication systems. The key deterrent in implementing a full-duplex wireless communication system, which

Abstract-We study full-duplex wireless communication systems where same band simultaneous bidirectional communication is achieved via cancellation of the self-interfering signal. Using offthe-shelf MIMO radios, we present experimental results that characterize the suppression performance of three self-interference cancellation mechanisms, which combine a different mix of analog and digital cancellation. Our experimental results show that while the amount of self-interference increases linearly with the transmitted power, the self-interference can be sufficiently cancelled to make full-duplex wireless communication feasible in many cases. Our experimental results further show that if the self-interference is cancelled in the analog domain before the interfering signal reaches the receiver front end, then the resulting full-duplex system can achieve rates higher than the rates achieved by a half-duplex system with identical analog resources.

In this paper, we present an experimental and simulation based study to evaluate the use of full-duplex as a mode in practical IEEE 802.11 networks. To enable the study, we designed a 20 MHz multi-antenna OFDM full-duplex physical layer and a full-duplex capable MAC protocol which is backward compatible with current 802.11. Our extensive over-the-air experiments, simulations and analysis demonstrate the following two results.First, the use of multiple antennas at the physical layer leads to a higher ergodic throughput than its hardwareequivalent multi-antenna half-duplex counterparts, for SNRs above the median SNR encountered in practical WiFi deployments. Second, the proposed MAC translates the physical layer rate gain into near doubling of throughput for multi-node single-AP networks. The two combined results allow us to conclude that there are potentially significant benefits gained from including a full-duplex mode in future WiFi standards.

No abstract

Abstract-Incorporating full duplex operation in Multiple Input Multiple Output (MIMO) systems provides the potential of boosting throughput performance. However, the hardware complexity of the analog self-interference canceller scales with the number of transmit and receive antennas, thus exploiting the benefits of analog cancellation becomes impractical for full duplex MIMO transceivers. In this paper, we present a novel architecture for the analog canceller comprising of reduced number of taps (tap refers to a line of fixed delay and variable phase shifter and attenuator) and simple multiplexers for efficient signal routing among the transmit and receive radio frequency chains. In contrast to the available analog cancellation architectures, the values for each tap and the configuration of the multiplexers are jointly designed with the digital beamforming filters according to certain performance objectives. Focusing on a narrowband flat fading channel model as an example, we present a general optimization framework for the joint design of analog cancellation and digital beamforming. We also detail a particular optimization objective together with its derived solution for the latter architectural components. Representative computer simulation results demonstrate the superiority of the proposed low complexity full duplex MIMO system over lately available ones.