No abstract

The potential of particle therapy due to focused dose deposition in the Bragg peak has not yet been fully realized due to inaccuracies in range verification. The purpose of this work was to correlate the Bragg peak location with target structure, by overlaying the location of the Bragg peak onto a standard ultrasound image. Pulsed delivery of 50 MeV protons was accomplished by a fast chopper installed between the ion source and the cyclotron inflector. The chopper limited the train of bunches so that 2 Gy were delivered in [Formula: see text]. The ion pulse generated thermoacoustic pulses that were detected by a cardiac ultrasound array, which also produced a grayscale ultrasound image. A filtered backprojection algorithm focused the received signal to the Bragg peak location with perfect co-registration to the ultrasound images. Data was collected in a room temperature water bath and gelatin phantom with a cavity designed to mimic the intestine, in which gas pockets can displace the Bragg peak. Phantom experiments performed with the cavity both empty and filled with olive oil confirmed that displacement of the Bragg peak due to anatomical change could be detected. Thermoacoustic range measurements in the waterbath agreed with Monte Carlo simulation within 1.2 mm. In the phantom, thermoacoustic range estimates and first-order range estimates from CT images agreed to within 1.5 mm.

LUX-ZEPLIN (LZ) is a second-generation direct dark matter experiment with spin-independent WIMP-nucleon scattering sensitivity above $${1.4 \times 10^{-48}}\, {\hbox {cm}}^{2}$$ 1.4 × 10 - 48 cm 2 for a WIMP mass of $${40}\, \hbox {GeV}/{\hbox {c}}^{2}$$ 40 GeV / c 2 and a $${1000}\, \hbox {days}$$ 1000 days exposure. LZ achieves this sensitivity through a combination of a large $${5.6}\, \hbox {t}$$ 5.6 t fiducial volume, active inner and outer veto systems, and radio-pure construction using materials with inherently low radioactivity content. The LZ collaboration performed an extensive radioassay campaign over a period of six years to inform material selection for construction and provide an input to the experimental background model against which any possible signal excess may be evaluated. The campaign and its results are described in this paper. We present assays of dust and radon daughters depositing on the surface of components as well as cleanliness controls necessary to maintain background expectations through detector construction and assembly. Finally, examples from the campaign to highlight fixed contaminant radioassays for the LZ photomultiplier tubes, quality control and quality assurance procedures through fabrication, radon emanation measurements of major sub-systems, and bespoke detector systems to assay scintillator are presented.

No abstract

The mixing and flowfield of a complex geometry, similar to a rearwardfacing step flow but with injection, is studied. A subsonic top-stream is expanded over a perforated ramp at an angle of 30 • , through which a secondary stream is injected. The mass flux of the second stream is chosen to be insufficient to provide the entrainment requirements of the shear layer, which, as a consequence, attaches to the lower guidewall. Part of the flow is directed upstream forming a re-entrant jet within the recirculation zone that enhances mixing and flameholding. A control-volume model of the flow is found to be in good agreement with the variation of the overall pressure coefficient of the device with variable mass injection. The flowfield response to changing levels of heat release is also quantified. While increased heat release acts somewhat analogously to increased mass injection, fundamental differences in the flow behaviour are observed. The hypergolic hydrogen-fluorine chemical reaction employed allows the level of molecular mixing in the flow to be inferred. The amount of mixing is found to be higher in the expansion-ramp geometry than in classical freeshear layers. As in free-shear layers, the level of mixing is found to decrease with increasing top-stream velocity. Results for a similar configuration with supersonic flow in the top stream are reported in Part II of this two-part series.