The photophysical properties of a series of monomeric, dimeric and trimeric oligodiacetylenes (ODAs; oligoenynes) bearing trimethylsilyl, t-butyl and n-octyl end-capping substituents were studied in solution and in a polymer film. Emission studies show a significant emission of oligodiacetylenes in solution, which increased with increased conjugation. This is remarkable given the near absence of fluorescence in oligoenes of similar length (e.g. hexatriene) and polydiacetylenes (PDAs), which constitute the conjugation limit. A large Stokes shift was observed, and shown to originate from an energy difference between the Franck-Condon excited state and the fluorescent state. From near-identical angles obtained for the absorption and emission dipoles it was concluded that the overall geometry of ODAs does not significantly change upon electronic transition.

No abstract

No abstract

The excited-state dynamics of an oligomer of polydiacetylene, 2,2,17,17-tetramethyloctadeca-5,9,13-trien-3,7,11,15-tetrayne, dissolved in n-hexane have been studied by femtosecond fluorescence upconversion and polarized transient absorption experiments under one- and two-photon excitation conditions. Spectroscopically monitoring the population relaxation in the excited states in real time results in a distinct time separation of the dynamics. It has been concluded that the observed dynamics can be fully accounted for on the basis of the two lower excited states of the target molecule. The S1 (2(1)Ag) state, which cannot be excited from the ground state with one-photon absorption, is verified to be populated via internal conversion in 200+/-40 fs from the strong dipole-allowed S2 (1(1)Bu) state. The population in the "hot" S1 state subsequently cools with a time constant of 6+/-1 ps and decays back to the ground state with a lifetime of 790+/-12 ps.

Starch oleate (degree of substitution = 2.2) films were cast and crosslinked in the presence of air using UV curing (UVC) or heat curing (HC). A commercial photoinitiator (CPI, Irgacure 184) and a natural photoinitiator (NPI, a mixture of biobased 3-hydroxyflavone and n-phenylglycine) were used for UVC. No initiator was used during HC. Isothermal gravimetric analyses, Fourier Transform Infrared (FTIR) measurements, and gel content measurements revealed that all three methods were effective in crosslinking, with HC being the most efficient. All methods increased the maximum strengths of film, with HC causing the largest increase (from 4.14 to 7.37 MPa). This is consistent with a higher degree of crosslinking occurring with HC. DSC analyses showed that the Tg signal flattened as film crosslink densities increased, even disappearing in the case of HC and UVC with CPI. Thermal gravimetric analyses (TGA) indicated that films cured with NPI were least affected by degradation during curing. These results suggest that cured starch oleate films could be suitable for replacing the fossil-fuel-derived plastics currently used in mulch films or packaging applications.