The abundant pigment-protein membrane complex photosystem-I (PS-I) is at the heart of the Earth’s energy cycle. It is the central molecule in the “Z-scheme” of photosynthesis, converting sunlight into the chemical energy of life. Commandeering this intricately organized photosynthetic nanocircuitry and re-wiring it to produce electricity carries the promise of inexpensive and environmentally friendly solar power. We here report that dry PS-I stabilized by surfactant peptides functioned as both the light-harvester and charge separator in solar cells self-assembled on nanostructured semiconductors. Contrary to previous attempts at biophotovoltaics requiring elaborate surface chemistries, thin film deposition, and illumination concentrated into narrow wavelength ranges the devices described here are straightforward and inexpensive to fabricate and perform well under standard sunlight yielding open circuit photovoltage of 0.5 V, fill factor of 71%, electrical power density of 81 µW/cm2 and photocurrent density of 362 µA/cm2, over four orders of magnitude higher than any photosystem-based biophotovoltaic to date.

Hydrogenases catalyze the interconversion of protons and hydrogen according to the reversible reaction: 2H(+) + 2e(-) ⇆ H(2) while using only the earth-abundant metals nickel and/or iron for catalysis. Due to their high activity for proton reduction and the technological significance of the H(+)/H(2) half reaction, it is important to characterize the catalytic activity of [FeFe]-hydrogenases using both biochemical and electrochemical techniques. Following a detailed electrochemical and photoelectrochemical study of an [FeFe]-hydrogenase from Clostridium acetobutylicum (CaHydA), we now report electrochemical and single-molecule imaging studies carried out on a catalytically active hydrogenase preparation. The enzyme CaHydA, a homologue (70% identity) of the [FeFe]-hydrogenase from Clostridium pasteurianum , CpI, was adsorbed to a negatively charged, self-assembled monolayer (SAM) for investigation by electrochemical scanning tunneling microscopy (EC-STM) techniques and macroscopic electrochemical measurements. The EC-STM imaging revealed uniform surface coverage with sufficient stability to undergo repeated scanning with a STM tip as well as other electrochemical investigations. Cyclic voltammetry yielded a characteristic cathodic hydrogen production signal when the potential was scanned sufficiently negative. The direct observation of the single enzyme distribution on the Au-SAM surface coupled with macroscopic electrochemical measurements obtained from the same electrode allowed the evaluation of a turnover frequency (TOF) as a function of potential for single [FeFe]-hydrogenase molecules.

There is considerable interest in making use of solar energy through photosynthesis to create alternative forms of fuel. Here, we show that photosystem I from a thermophilic bacterium and cytochrome-c(6) can, in combination with a platinum catalyst, generate a stable supply of hydrogen in vitro upon illumination. The self-organized platinization of the photosystem I nanoparticles allows electron transport from sodium ascorbate to photosystem I via cytochrome-c(6) and finally to the platinum catalyst, where hydrogen gas is formed. Our system produces hydrogen at temperatures up to 55 degrees C and is temporally stable for >85 days with no decrease in hydrogen yield when tested intermittently. The maximum yield is approximately 5.5 micromol H(2) h(-1) mg(-1) chlorophyll and is estimated to be approximately 25-fold greater than current biomass-to-fuel strategies. Future work will further improve this yield by increasing the kinetics of electron transfer, extending the spectral response and replacing the platinum catalyst with a renewable hydrogenase.

We used a class of designed peptide detergents to stabilize photosystem I (PS-I) upon extended drying under N2 on a gold-coated-Ni-NTA glass surface. PS-I is a chlorophyll-containing membrane protein complex that is the primary reducer of ferredoxin and the electron acceptor of plastocyanin. We isolated the complex from the thylakoids of spinach chloroplasts using a chemical detergent. The chlorophyll molecules associated with the PS-I complex provide an intrinsic steady-state emission spectrum between 650 and 800 nm at −196.15 °C that reflects the organization of the pigment-protein interactions. In the absence of detergents, a large blue shift of the fluorescence maxima from approximately 735 nm to approximately 685 nm indicates a disruption in light-harvesting subunit organization, thus revealing chlorophyll−protein interactions. The commonly used membrane protein-stabilizing detergents, N-dodecyl-β-D-maltoside and N-octyl-β-D-glucoside, only partially stabilized the approximately 735-nm complex with approximately 685-nm spectroscopic shift. However, prior to drying, addition of the peptide detergent acetyl- AAAAAAK at increasing concentration significantly stabilized the PS-I complex. Moreover, in the presence of acetyl- AAAAAAK, the PS-I complex is stable in a dried form at room temperature for at least 3 wk. Another peptide detergent, acetyl-VVVVVVD, also stabilized the complex but to a lesser extent. These observations suggest that the peptide detergents may effectively stabilize membrane proteins in the solid-state. These designed peptide detergents may facilitate the study of diverse types of membrane proteins.

Detailed structural analyses of membrane proteins as well as their uses in advanced nanobiotechnological applications require extended stabilization of the functional protein conformation. Here we report that a new class of designer surfactant like peptides can significantly increase the activity and stabilize the functional form of the multidomain protein complex Photosystem-I (PS-I) in solution better than other commonly used chemical detergents. We carried out a systematic analysis using a series of such peptides to identify the chemical and structural features that enhance the photochemical activity of PS-I. We observed that peptide surfactant amphiphilicity is necessary but not sufficient to stabilize PS-I in its functional form. A number of factors are essential for designing the optimal peptide including amino acid sequence, N-terminal acetylation and C-terminal amidation. Furthermore, we showed that the polarity and number of charges on the hydrophilic head are important as well as hydrophobicity and size of the amino acid side groups in the hydrophobic tail play an important role. The best performing peptides for the stabilization of functional PS-I are, in order of effectiveness, ac-I(6)K(2)-CONH(2), ac-A(6)K-CONH(2), ac-V(6)K(2)-CONH(2), and ac-V(6)R(2)-CONH(2). These simple and inexpensive peptide surfactants will likely make significant contributions to stabilize the functional form of diverse and currently elusive membrane proteins and their complexes with important applications.