The rapid development of the number of wireless broadband devices requires that the induced uplink exposure be addressed during the design of the future wireless networks, in addition to the downlink exposure due to the transmission of the base stations. In this paper, the positions and power levels of massive MIMO-LTE (Multiple Input Multiple Output-Long Term Evolution) base stations are optimized towards low power consumption, low downlink and uplink electromagnetic exposure and maximal user coverage. A suburban area in Ghent, Belgium has been considered. The results show that the higher the number of BS antenna elements, the fewer number of BSs the massive MIMO network requires. This leads to a decrease of the downlink exposure (−12% for the electric field and −32% for the downlink dose) and an increase of the uplink exposure (+70% for the uplink dose), whereas both downlink and uplink exposure increase with the number of simultaneous served users (+174% for the electric field and +22% for the uplink SAR). The optimal massive MIMO network presenting the better trade-off between the power consumption, the total dose and the user coverage has been obtained with 37 64-antenna BSs. Moreover, the level of the downlink electromagnetic exposure (electric field) of the massive MIMO network is 5 times lower than the 4G reference scenario.

The next fifth generation (5G) of wireless communication networks comes with a set of new features to satisfy the demand of data-intensive applications: millimeter-wave frequencies, massive antenna arrays, beamforming, dense cells, and so forth. In this paper, we investigate the use of beamforming techniques through various architectures and evaluate the performance of 5G wireless access networks, using a capacity-based network deployment tool. This tool is proposed and applied to a realistic area in Ghent, Belgium, to simulate realistic 5G networks that respond to the instantaneous bit rate required by the active users. The results show that, with beamforming, 5G networks require almost 15% more base stations and 4 times less power to provide more capacity to the users and the same coverage performances, in comparison with the 4G reference network. Moreover, they are 3 times more energy efficient than the 4G network and the hybrid beamforming architecture appears to be a suitable architecture for beamforming to be considered when designing a 5G cellular network.

Massive MIMO techniques are expected to deliver significant performance gains for the future wireless communication networks by improving the spectral and the energy efficiencies. In this paper, we propose a method to optimize the positions, the coverage, and the energy consumption of the massive MIMO base stations within a suburban area in Ghent, Belgium, while meeting the low power requirements. The results reveal that massive MIMO provides better performances for the crowded scenario where users’ mobility is limited. With 256 antennas, a massive MIMO base station can simultaneously multiplex 18 users at the same time-frequency resource while consuming 8 times less power and providing 200 times more capacity than a 4G reference network for the same coverage. Moreover, a pilot reuse pattern of 3 is recommended in a multiuser multicell environment to obtain a good tradeoff between the high spectral efficiency and the low power requirement.

The design of a massive MIMO network requires a channel model that captures the Spatio-temporal dimensions of the propagation environment. In this paper, we propose a novel method combining Hybrid Raytracing -Finite difference time domain (FDTD) and network planner tools to address this requirement. This method provides accurate and realistic EMF exposure models for the design of a massive MIMO network. Using this method, we proceed with the optimization of the BS's locations under the low power consumption and low EMF exposure constraints. Assuming equal preference of the optimization objectives, the simulations show that the uplink localized 10g dose appears to be the dominant factor of the localized 10g EMF exposure. Moreover, a massive MIMO network designed to serve 224 simultaneous active users at the same time-frequency resource is subject to an increase of the total whole-body dose (2 times higher in downlink and +18% in uplink), compared to a design with 14 active users. However, in the same conditions, the downlink localized 10g dose reduces (20 times lower) whereas the uplink localized 10g dose increases (+23%) in comparison with the scenario with fewer users (14). Besides, the electromagnetic field strength in all locations obtained with this new method is 2 times weaker compared to a 4G LTE network, while complying with the international guidelines.INDEX TERMS 5G, antenna arrays, beamforming, EMF exposure, massive MIMO, power consumption, network planner, precoding, ray-tracing.