No abstract

The connection between cytoskeleton alterations and diseases is well known and has stimulated research on cell mechanics, aiming to develop reliable biomarkers. In this study, we present results on rheological, adhesion, and morphological properties of primary rat cardiac fibroblasts, the cytoskeleton of which was altered by treatment with cytochalasin D (Cyt-D) and nocodazole (Noc), respectively. We used two complementary techniques: quartz crystal microbalance (QCM) and digital holographic microscopy (DHM). Qualitative data on cell viscoelasticity and adhesion changes at the cell–substrate near-interface layer were obtained with QCM, while DHM allowed the measurement of morphological changes due to the cytoskeletal alterations. A rapid effect of Cyt-D was observed, leading to a reduction in cell viscosity, loss of adhesion, and cell rounding, often followed by detachment from the surface. Noc treatment, instead, induced slower but continuous variations in the rheological behavior for four hours of treatment. The higher vibrational energy dissipation reflected the cell’s ability to maintain a stable attachment to the substrate, while a cytoskeletal rearrangement occurs. In fact, along with the complete disaggregation of microtubules at prolonged drug exposure, a compensatory effect of actin polymerization emerged, with increased stress fiber formation.

Single-cell adhesion measured with atomic force microscopy (AFM) offers outstanding time and force resolution and allows the investigation of many important phenomena with unmatched precision. However, this technique suffers from serious practical limitations that hinder its effective application to a broader set of situations. Here we propose a different strategy based on the fabrication of large cantilevers and on the culture of the cells directly on them. Cantilevers are fabricated by standard micromachining, with an active area of 300 × 300 µm. A wedged structure is created so that the cantilever surface lies parallel to the substrate when mounted on an AFM system, so that the adhesion measurement probes the whole surface area at the same time. Thanks to the large area, cells can be seeded and grown on the cantilevers the day before the experiment, and let recover to optimal condition for the experiment. We used Human Embryonic Kidney cells, HEK 293A, to demonstrate the measurement of adhesion forces of up to 100 cells in parallel, and obtain a straightforward measurement of the average single cell adhesion energy. Our approach can improve significantly the cell-cell and cell-substrate adhesion statistics, reduce the experiment time and allow the investigation of the adhesion properties of cells that do not grow well in solution or on low adherent substrates, or that develop their characteristic features only after several hours or days of culture on a solid and adherent substrate.