No abstract

No abstract

Implementation of alternative fuels in gas turbine facilities is a challenging step towards cleaner and more responsible energy production. Despite numerous technical, economical and legal obstacles, possibilities for partial or complete substitution of fossil fuels are still subject of profound research. From all possible solutions, one with high acceptance is the symbiosis of existing gas turbine technologies and new ways of waste biomass energy utilization through firing or co-firing of biomass gasification gas. Therefore, the implementation of corn cob gasification gas with CO2 recirculation in gas turbines is analyzed in this paper. The followed methodology approaches this solution through two different scenarios each with 5 different cases. In the first scenario fuel mass flows are kept constant regardless of the fuel quality change consequence of the corn cob gas share, while in the second scenario fuel volume flows are assumed constant. Impact of fuel composition changes on combustion product characteristics was analyzed using CHEMKIN PRO with GRI-Mech 3.0. Finally, fuel quality impacts on a gas turbine power plant performance are analyzed using a mathematical model that enables the simulation of a 3.9 MW

Carbon emissions reduction via the increase of sustainable energy sources in need of storage defines chemicals such as ammonia as one of the promising solutions for reliable power decarbonisation. However, the implementation of ammonia for fuelling purposes in gas turbines for industry and energy production is challenging when compared to current gas turbines fuelled with methane. One major concern is the efficiency of such systems, as this has direct implications in the profitability of these power schemes. Previous works performed around parameters prediction of standard gas turbine cycles showed that the implementation of ammonia/hydrogen as a fuel for gas turbines presents very limited overall efficiencies. Therefore, this paper covers a new approach of parameters prediction consisting of series of analytical and numerical studies used to determine emissions and efficiencies of a redesigned Brayton cycle fuelled with humidified ammonia/hydrogen blends. The combustion analysis was done using CHEMKIN‐PRO (ANSYS, Canonsburg, PA, USA), and the results were used for determination of the combustion efficiency. Chemical kinetic results denote the production of very low NOx as a consequence of the recombination of species in a post combustion zone, thus delivering atmospheres with 99.2% vol. clean products. Further corrections to the cycle (i.e., compressor and turbine size) followed, indicating that the use of humidified ammonia-hydrogen blends with a total the amount of fuel added of 10.45 MW can produce total plant efficiencies ~34%. Values of the gas turbine cycle inlet parameters were varied and tested in order to determine sensibilities to these modifications, allowing changes of the analysed outlet parameters below 5%. The best results were used as inputs to determine the final efficiency of an improved Brayton cycle fuelled with humidified ammonia/hydrogen, reaching values up to 43.3% efficiency. It was notorious that humidification at the injector was irrelevant due to the high water production (up to 39.9%) at the combustion chamber, whilst further research is recommended to employ the unburned ammonia (0.6% vol. concentration) for the reduction of NOx left in the system (~10 ppm).

Clean, more responsible energy production in gas turbine power plants is a challenge. Interestingly, various alternative sources could be found in agricultural locations with great potential of being transformed from agricultural waste to energy. Corn cob gasification gas could be successfully implemented in gas turbines through co-firing with natural gas. Concurrently, agricultural biogas could also be employed for such a purpose. The technology could be implemented in locations such as Vojvodina, Serbia, which is an agricultural region with great potential for producing biogas from agricultural waste. Therefore, this paper approaches the practical implementation of gas produced by adiabatic corn digestion with CO2 recirculation. Five different cases were assessed. The results are compared to previous analyses that used co-firing of the corn cob gasification gas in representative gas turbine systems. Impacts of the fuel composition on the characteristics of combustion were analyzed using CHEMKIN PRO with GRI–Mech 3.0. Impacts of fuel quality on the power plant performance were analyzed through calculations with a numerical model based on a Brayton cycle of 3.9 MW power output. The application shows acceptable values during co-firing with natural gas without modification of the overall system, with better outlet parameters compared to pure corn gasification gas.