Soybean hull peroxidase (SHP, E.C. 1.11.1.7) was immobilized by a glutaraldehyde and periodate method onto series of macroporous copolymers of glycidyl methacrylate (GMA) and ethylene glycol dimethacrylate (EGDMA), poly(GMA-co-EGDMA) with various surface characteristics and pore size diameters ranging from 44 to 200 nm. Glutaraldehyde immobilization method and poly(GMA-co-EGDMA) named SGE 20/12 with pore sizes of 120 nm gave immobilized enzyme with highest specific activity of 25 U/g. Deactivation studies showed that immobilization increased stability of SHP and that surface characteristics of the used copolymer had a major influence on a stability of immobilized enzyme at high temperatures and in an organic solvent. The highest thermostability was obtained using the copolymer SGE 20/12 with pore size of 120 nm, while the highest stability in dioxane had SHP immobilized onto copolymer SGE 10/4 with pore size of 44 nm. Immobilized SHP showed a wider pH optimum as compared to the native enzyme especially at alkaline pH values and 3.2 times increased K m value for pyrogallol. After 6 cycles of repeated use in batch reactor, immobilized SHP retained 25 % of its original activity. Macroporous copolymers with different surface characteristics can be used for fine tuning of activity and stability of immobilized SHP to obtain a biocatalyst suitable for phenol oxidation or polymer synthesis in organic solvents.

A macroporous copolymer of glycidyl methacrylate and ethylene glycol dimethacrylate, poly(GMA-co-EGDMA), with various surface characteristics and mean pore size diameters ranging from 44 to 200 nm was synthesized, modified with 1,2-diaminoethane, and tested as a carrier for immobilization of horseradish peroxidase (HRP) by two covalent methods, glutaraldehyde and periodate. The highest specific activity of around 35 U g(-1) dry weight of carrier was achieved on poly(GMA-co-EGDMA) copolymers with mean pore diameters of 200 and 120 nm by the periodate method. A study of deactivation kinetics at 65 °C and in 80 % dioxane revealed that periodate immobilization also produced an appreciable stabilization of the biocatalyst, while stabilization factor depended strongly on the surface characteristics of the copolymers. HRP immobilized on copolymer with a mean pore diameter of 120 nm by periodate method showing not only the highest specific activity but also good stability was further characterized. It appeared that the immobilization resulted in the stabilization of enzyme over a broader pH range while the Michaelis constant value (K (m)) of the immobilized HRP was 10.8 mM, approximately 5.6 times higher than that of the free enzyme. After 6 cycles of repeated use in a batch reactor for pyrogallol oxidation, the immobilized HRP retained 45 % of its original activity.

No abstract

Immobilization of horseradish peroxidase (HRP) within alginate beads was enabled by chemical modification of the enzyme and polysaccharide chains. HRP and alginate were oxidized by periodate and subsequently modified with ethylenediamine. Highest specific activity of 0.43 U/ml of gel and 81% of bound enzyme activity was obtained using aminated HRP and alginate oxidized by periodate. Immobilized enzyme retained 75% of its original activity after 2 days of incubation in 80% (v/v) dioxane and had increased activity in basic solutions compared to native enzyme. During repeated use in batch reactor for pyrogallol oxidation immobilized peroxidase retained 75% of its original activity.

Pectin was modified by oxidation with sodium periodate at molar ratios of 2.5, 5, 10, 15 and 20 mol% and reductive amination with tyramine and sodium cyanoborohydride afterwards. Concentration of tyramine groups within modified pectin ranged from 54.5 to 538 μmol/g of dry pectin while concentration of ionizable groups ranged from 3.0 to 4.0 mmol/g of dry polymer compared to 1.5 mmol/g before modification due to the introduction of amino group. All tyramine-pectins showed exceptional gelling properties and could form hydrogel both by cross-linking of carboxyl groups with calcium or by cross-linking phenol groups with peroxidase in the presence of hydrogen peroxide. These hydrogels were tested as carriers for soybean hull peroxidase (SHP) immobilization within microbeads formed in an emulsion based enzymatic polymerization reaction. SHP immobilized within tyramine-pectin microbeads had an increased thermal and organic solvent stability compared to the soluble enzyme. Immobilized SHP was more active in acidic pH region and had slightly decreased K value of 2.61 mM compared to the soluble enzyme. After 7 cycles of repeated use in batch reactor for pyrogallol oxidation microbeads, immobilized SHP retained half of the initial activity.