Sitting time in older adults can be reliably measured with a reported measure (a recall strategy) over a 1-week interval. Older adults who spend more time sitting are more likely to experience mobility limitation.

To examine the association between endometriosis and the risk of systemic lupus erythematosus (SLE), this nationwide, population-based, retrospective cohort study was conducted based on National Health Insurance Research Database in Taiwan. Endometriosis (N = 16,758) and non-endometriosis (N = 16,758) groups were identified by matching baseline characteristics and comorbidities. Student’s t-tests and the Kaplan–Meier estimator were utilized to estimate the hazard ratio (HR) and cumulative probability of SLE in the two groups. The endometriosis group showed a significantly higher incidence density rate (0.3 vs. 0.1 per 1000 person-years) and hazard ratio in SLE group (adjusted HR [aHR], 2.37; 95% confidence interval [CI] 1.35–4.14) compared to the non-endometriosis group. Subgroup analysis revealed that patients with endometriosis between 30 and 45 years of age, or were non-steroidal anti-inflammatory drug users, or were hormonal medications-free participants, had higher risks of SLE. For patients with endometriosis, surgical intervention did not significantly impact on the risk of SLE. Our results demonstrated an increased risk of SLE in patients with endometriosis. Clinicians should be aware of this association when managing patients with endometriosis or SLE.

No abstract

No abstract

Powder metallurgy (PM) has been widely used to produce various steels in industry, mainly due to its capabilities for manufacturing nearly net-shaped products and mass production. To improve the performances of PM stainless steels, the roles of 0.6 wt% B additive in the microstructures, mechanical properties, and corrosion resistances of PM 304L austenitic, 410L ferritic, and 410 martensitic stainless steels were investigated. The results showed that adding 0.6 wt% B significantly improved the sintered densities of the three kinds of stainless steels due to the liquid phase sintering (LPS) phenomenon. The borides in 304L + 0.6B, 410L + 0.6B, and 410 + 0.6B were rich in B and Cr atoms but deficient in Fe, Ni, or C atoms, as analyzed by electron probe micro-analysis. Furthermore, the B additive contributed to the improved apparent hardness and corrosion resistance of PM stainless steels. In the 410L stainless steel, the 0.6 wt% B addition increased the corrosion voltage from −0.43 VSCE to −0.24 VSCE and reduced the corrosion current density from 2.27 × 10−6 A/cm2 to 1.93 × 10−7 A/cm2. The effects of several factors, namely: porosity; the generation of boride; the matrix/boride interfacial areas; Cr depletion; and the microstructure on the corrosion performances are discussed. The findings clearly indicate that porosity plays a predominant role in the corrosion resistances of PM austenitic, ferritic, and martensitic stainless steels.