No abstract

CMOS analog baseband circuits including a low-pass filter (LPF) and a programmable gain amplifier (PGA) are designed and implemented for the fifth-generation (5G) mobile communication. The super source follower topology is adopted to achieve a wideband LPF with good linearity, while the constant current density gain control technique is used to implement gain cells of the PGA. The circuits are integrated as an analog baseband for a 5G transmitter (TX) and fabricated using TSMC 90-nm CMOS technology. The analog baseband exhibits the bandwidth from 1.03 to 1.05 GHz when the voltage gain is varied from −18.9 dB to 3.8 dB in 1-dB steps. The gain step errors are within −0.7 dB to 0.9 dB. In the highest gain mode, the analog baseband achieves the IP1dB of −10 dBv and the IIP3 of −0.2 dBv. Over the band of interest, the NF of the analog baseband is 24.4–40.0 dB.

No abstract

A variable-gain chopper-stabilized instrumentation amplifier (chopper IA), which employs a low pass filter (LPF) to attenuate the up-converted noise at the chopping frequency, is presented. The circuit is designed and fabricated with Taiwan Semiconductor Manufacturing Company (TSMC) (Hsinchu, Taiwan) 0.18 μm complementary metal-oxide-semiconductor (CMOS) technology. Consuming 1.1 mW from a 1.2 V supply voltage, the chopper IA achieves a variable gain of 20.7–48.5 dB, with a minimum bandwidth of 6.7 kHz and a common-mode rejection ratio (CMRR) of 95 dB below 10 kHz. By using the chopper technique, the input-referred noise of the chopper IA can be reduced to 0.28 μVrms (0~96 kHz), with a chopping frequency of 83.3 kHz. An automatic frequency tuning loop (ATL) is employed to adjust the corner frequency of the LPF dynamically so that the frequency ratio between the chopping frequency and the LPF corner frequency is 8.3, ensuring a noise reduction of 36.7 dB.

No abstract