No abstract

In this paper, tip clearance flow (TCF) instabilities and their relationship to blade motion are investigated numerically on a transonic transonic rotor with a large tip clearance. The numerical methods are verified by comparing with the experimental data of NACA0012 and show reliable results. It is found that the TCF instabilities are caused by the radial vortex formed in passage, which is induced by the interaction of tip clearance vortex (TCV) and main flow. When the blade is enforced vibrating with small amplitude, the results show that TCF instabilities are hardly affected by the blade vibration, and almost no phenomenon of locked-in is found. However, when the amplitude of blade vibration is increased, the interaction becomes stronger and the pressure fluctuation is enhanced. A wider locked-in region is observed. In addition, the simulation results show that the locked-in region is affected significantly by modal shapes. For the rotor here, it seems that the bending mode has a greater effect on the TCV instabilities than the torsional mode and causes a wider locked-in region. In locked-in region, the phase differences between TCV and the blade motion change with the flow conditions. In unlocked region, the period of TCF instabilities fluctuates over time, and the process is similar to that in the locked-in region.

The tubed vortex reducer in the axial compressor can destroy the vortex in the disk cavity, by a thin-walled tube, to reduce the total pressure loss. The tube may suffer from vibration problems, such as flutter and forced vibration, which are closely related to aerodynamic damping. In this paper, the energy method and the influence coefficient method are used to study the aerodynamic damping of the tube. Based on the modal characteristics, steady and unsteady flow characteristics of the tube, the first and second modes with lower frequencies and greater vibration risk are selected as the analysis objects. The energy method is used to calculate the aerodynamic damping of the tube with different amplitudes, which shows that the results approximately meet the linear assumption and are accurate. The results obtained by the influence coefficient method show that the aerodynamic influence between adjacent tubes is very small, and the effect of inter-tube phase angle on the aerodynamic damping can be ignored. Finally, it is found that the effect of structural coupling caused by the support ring on the aerodynamic damping of the tube is mainly reflected in two aspects: frequency reduction and tube mode coupling.

Flutter is one of the important issues in turbomachinery analysis. There are four common types of flutter, including sub/transonic stall flutter, choke flutter, supersonic stall flutter, and supersonic non-stall flutter. Flutter may occur under many different operating conditions. Therefore, it is important to study the aeroelastic stability of blades when the compressor operates under different conditions. Based on the energy method proposed by Carta [1], this paper studied the aeroelastic stability of the second-stage rotor blade of an axial compressor under different operating conditions. It is found that the aerodynamic damping of the blade under the near-stall operating point of the compressor is negative. Three typical operating points are selected to study the differences in flutter mechanism between different operating conditions. The 90% span section is selected as the reference section to analyze the variation of the aerodynamic work at different operating points. The influence of reduced frequency, modal component, and tip clearance on aerodynamic damping are analyzed under three operating points.