Plastic pollution has become a global concern due to poor plastic waste disposal management. As an alternative, independent recycling efforts are necessary. A Plastic shredder machine is a preliminary machine used to cut plastic waste into small pieces before turning it into useful products. The concept design of the shredder machine that is currently available is fairly similar. The shaft and blades are the critical components in the shredder machine that determines its performance. The geometry and orientation of the blades that were fitted into the single or double-shafts were found to directly affect the shredding performance. Therefore, this article aims to review the various geometry and orientations of the blades that give direct effect on the shredding performance, as well as identifying the research gaps related to the shredder machine for plastic waste materials

Carbon was successfully deposited on AISI 304 stainless steel rod cathode through electrolysis process in three molten salt mixtures, namely K2CO3-Li2CO3 (mole ratio: 1:1), CaCO3-Li2CO3-LiCl (mole ratio 0.09:0.28:0.63) and CaCO3-CaCl2-KCl-LiCl (mole ratio: 0.13:0.31:0.10:0.45), under CO2 atmospheres as continuous source of carbon. The process were carried out for 1 hour at temperature range 545–585°C and electrolysis voltage of 4.0V to drive the deposition of carbon through electrochemical conversion. EDX analysis on deposited products shown carbon as dominant element (89-98%). SEM revealed carbon with Flakes and grapes aggregation shapes for different salt mixtures. The achieved current efficiency of 83.8%, 80.46% and 92.41% were found in the respective salt mixtures, and energy consumption promotes several ways for efficiency improvement on the electrochemical conversion of CO2.