This study analyzes the stability and optimizes the parameters of the bottom structure in sublevel stoping with the delayed backfilling method, improves production efficiency, and increases the ore recovery ratio under the premise of ensuring safe production. Theoretical formulas are used to calculate the stability of the pillar with the bottom structure. Numerical simulation is used to study the stability of muck slash during excavation. Finally, the optimization parameters of the bottom structure are obtained by combining a similar physical experimental model and numerical simulation. The results show that the excavation of the muck slash caused different degrees of deformation at the roof and floor of the roadway. The largest stress occurred at the roadway crossing, whereas the smallest stress was in the middle area. The excavation also caused the secondary stress concentration at the adjacent bottom structure but did not significantly impact its stability. During the mining process, the largest displacement deformation occurred at the roadway crossing, and the influence of mining disturbance on the stability of the bottom structure involves timeliness and periodicity. Considering the recovery ratio, dilution ratio, and stability, the spacing of the extracted ore drift is recommended to be 9 m. This study ensures the stability of the bottom structure in the mining process and obtained reasonable parameters of the extracted ore drift, which provides a scientific way for the mines that use sublevel stoping with the delayed backfilling method.

Non-pillar sublevel caving is beginning to use large structural parameters in China. Appropriate structural parameters can effectively control the loss and dilution of stope and improve ore drawing efficiency. In this study, taking Chengchao Iron Mine as the engineering background, a theoretical calculation, a numerical simulation, and physical similarity experiments were combined to optimize sublevel height, production drift spacing, and drawing space. The optimal structural parameter range, based on the ellipsoid ore drawing theory, was obtained as a theoretical reference for subsequent studies. A “two-step” strategy was used, in which PFC2D software (Itasca Consulting Group, Minneapolis, MN, USA) was used to numerically simulate 20 groups of different sublevel heights and production drift spacing parameters were used to determine the appropriate sublevel height and production drift spacing for the project. Subsequently, the optimization of the ore drawing space was studied using PFC3D (Itasca Consulting Group, Minneapolis, MN, USA) particle unit software, numerical simulation analysis, and similar physical experiments. The results showed that safe and efficient mining can be achieved when the structural parameters of the stope are 17.5 m sublevel height, 20 m production drift spacing, and 6 m drawing space. The findings of this study can further the goal of green and efficient mining, and provide a theoretical reference for the popularization and application of pillarless sublevel caving with large structural parameters at home and abroad. It is an effective measure for the green mining of caving mines.

The rapid settlement of tailings is an important technical guarantee for the continuous production of downhole filling. The selection of a reasonable flocculant is essential for accelerating the settlement speed of classified fine tailings. The present paper conducts indoor static sedimentation experiments, NMR observation, electron microscope scanning, and other methods to analyze the porosity and pore-size distribution characteristics of floc solution for classified fine tailing under four flocculants, namely, ZYZ, ZYD, JYC-1, and JYC-2. The dimension, spatial distribution characteristics, particle size characteristics, and morphological characteristics of the scanning electron microscope images of floc were studied. Results show that the unit consumption of flocculant at 30 g/t is the critical value for increasing the flocculation and sedimentation effect of the classified fine tailings solution. The highest distribution percentage of small-sized classified fine tailings and the lowest average pore size was observed under the ZYZ-type flocculant. This flocculant also obtained the lowest porosity, largest average floc size, largest area occupied by the floc, lowest pore percentage, and the densest floc structure. Thus, this flocculant showed the best flocculation effect. A negative correlation was observed between the equivalent diameter of floc with varying settlement heights. The dimension of floc increased with the decrease in bed settlement height, and the overall structure of the floc gradually transitioned from loose to dense from top to bottom. The present paper characterizes the microscopic morphology and spatial structure characteristics of floc under different flocculants from a microscopic point of view. The present paper also provides a scientific basis for the selection of the optimal flocculant.