No abstract

No abstract

Steel slag is one of the most common waste products from the steelmaking industry. Conventional methods of slag disposal can cause negative impacts on humans and the environment. In this paper, the process of steel and steel slag production, physical and chemical properties, and potential options of slag recycling were reviewed. Since steel is mainly produced through an electric arc furnace (EAF) in Malaysia, most of the recycling options reviewed in this paper focused on EAF slag and the strengths and weaknesses of each recycle option were outlined. Based on the reports from previous studies, it was found that only a portion of EAF slag is recycled into more straightforward, but lower added value applications such as aggregates for the construction industry and filter/absorber for wastewater treatments. On the other hand, higher added value recycling options for EAF slag that are more complicated such as incorporated as raw material for Portland cement and ceramic building materials remain at the laboratory testing stage. The main hurdle preventing EAF slag from being incorporated as a raw material for higher added value industrial applications is its inconsistent chemical composition. The chemical composition of EAF slag can vary based on the scrap metal used for steel production. For this, mineral separation techniques can be introduced to classify the EAF slag base on its physical and chemical compositions. We concluded that future research on recycling EAF slag should focus on separation techniques that diversify the recycling options for EAF slag, thereby increasing the waste product’s recycling rate.

Zinc-air batteries were fabricated using porous zinc anodes with various concentrations of Super P carbon black additive. The introduction of Super P significantly improved the electrochemical performance of the batteries. The specific discharge capacity and power density of the Zn anode with 2 wt% Super P anode was 776 mA h g−1 and 20 mW cm−2, respectively. The batteries also exhibited good durability and stability at an open circuit voltage maintained at approximately 1.4 V. The bridging between Zn powders by Super P may explain the improved electrochemical performance of the batteries. Morphological images and structural properties were also analyzed to support these observations.

Cellulose nanofibers (CNF) were isolated fromGigantochloa scortechiniibamboo fibers using sulphuric acid hydrolysis. This method was compared with pulping and bleaching process for bamboo fiber. Scanning electron microscopy, transmission electron microscopy, Fourier transform infrared spectroscopy, X-ray diffraction, and thermogravimetric analysis were used to determine the properties of CNF. Structural analysis by FT-IR showed that lignin and hemicelluloses were effectively removed from pulp, bleached fibers, and CNF. It was found that CNF exhibited uniform and smooth morphological structures, with fiber diameter ranges from 5 to 10 nm. The percentage of crystallinity was significantly increased from raw fibers to cellulose nanofibers, microfibrillated, along with significant improvement in thermal stability. Further, obtained CNF were used as reinforcement material in epoxy based nanocomposites where tensile strength, flexural strength, and modulus of nanocomposites improved with the addition of CNF loading concentration ranges from 0 to 0.7%.