No abstract

In this paper, power-sharing management control on an AC islanded microgrid is investigated to achieve accurate reactive power sharing. The droop control method is primarily used to manage the active and reactive power sharing among the DGs in the microgrid. However, the line impedance mismatch causes unbalanced reactive power sharing. As a solution a consensus-based adaptive virtual impedance controller is proposed, where the consensus algorithm is used to set the reactive power mismatch; then a virtual impedance correction term is generated through a proportional-integral controller to eliminate the line impedance mismatch. Thus, reactive power sharing is achieved without knowledge of the line impedances or using a central controller. Moreover, the consensus algorithm is used to restore the AC bus voltage to the nominal value by estimating the DGs average voltage using neighbor communication to compensate for the decreased magnitude of the voltage reference. Matlab/Simulink is used to validate the accuracy of reactive power sharing and voltage restauration achievement of the proposed solution through simulation of different scenarios. In addition, a dSPACE DS1104 is used within a developed experimental testbench based on two parallel DGs to validate the effectiveness of the proposed solution in the real world.

<p>In this paper, an optimization of PV grid connected system is investigated. This is achieved by considering the application of artificial intelligence in the DC side to realize maximal power extraction, and using a sine-band hysteresis control in the AC side of the system, to generate a sine current/voltage suitable for grid connection IEEE929-2000 standards. The overall system has been simulated taking into account environmental effects and standards constraints in order to achieve best performance. The choice of sine band hysteresis control was selected considering its implementation simplicity. The algorithm runs fast on a low-cost microcontroller allowing to avoid any delay that can cause a phase shift in the system.  An experimental setup has been realized for tests and validation purposes. Both simulation and experimental results lead to satisfactory results which are conform to the IEEE929-2000 standards.</p>

No abstract

No abstract