An integrated reservoir study was initiated to look for new opportunities in East Zeit field. The working team managed to construct the full field static and dynamic models. The main challenge during the history match phase was the high complexity of the structure, range of uncertainties, and the model running time. The team managed to understand unconventional reservoir aspects such as:(1) The reservoir pressure was sharply decreases as production increases. Then, when the reservoir was abandoned as a depletion drive reservoir the pressure started to increase up to initial reservoir pressure without any intervention.(2) The performance of few wells completed in the above mentioned reservoir was similar to the performance of wells in active water drive reservoirs.Comprehensive work in the history match has been done to calibrate the model and explain the different phenomena in the field. The team explained the pressure increase in the depleted reservoir that it was due to the reactivation of faults which became non-sealing. This resulted in communication with another active water drive reservoir and natural miscibility process. The study recommended adding new off take point in the reservoir to confirm the concept. So, a new well was drilled and confirmed the study conclusion and managed to add more reserves and production in the rejuvenated reservoir after 12 years of shut in. Currently, constructing complete field development plan is in progress to maximize the recovery factor. Reservoir monitoring even after abandonment, especially with unconventional reservoir aspects, is very important to discover new opportunities and maximize the recovery. These opportunities should be managed through the integrated reservoir simulation studies to minimize the risk and cover the uncertainties.

A Paleocene dolomite in northeastern Libya was modeled using three porosity types: matrix porosity (intercrystalline plus the separate vugs), horizontal-to-subhorizontal solution-enlarged vuggy porosity generated by dissolution and named "touching vugs," and fracture porosity.The touching vugs, which acted like fractures in their dynamic behavior, are modeled as a very permeable discrete fracture network (DFN) in PETREL* seismic-to-simulation software. Their presence is known primarily due to pressure buildup analysis, and it is expected that they would be interconnected over hundreds of meters.The primary challenge in dual-media modeling is being able to characterize and predict the dynamic behavior of the complex matrix + fracture + touching vug system. There are three wells in this area of northeastern Libya with pressure buildups that have an unusually distinct and pronounced dual-porosity signature. Each well has been matched by adjusting the five primary parameters: matrix and fracture porosity and permeability, and the sigma shape factor. Aquifer strength also had to be adjusted.There are some aspects of the dynamic behavior of this reservoir that are of particular interest: • The highly fractured low-porosity parts of the reservoir are the least productive, and the least fractured high-porosity parts with touching vugs are the most productive.• The well test shows pronounced dual-porosity behavior and indicates a high level of contrast between the matrix and secondary porosity systems, both in terms of permeability and porosity. • There is a strong aquifer and in reservoirs with moderate fracture permeability, we would expect to see the fractures provide a pathway for rapid water breakthrough. Owing to the very high permeability associated with the fracture system, this does not happen as expected; i.e., the reservoir acts to some extent like a tank with a level oil/water contact (OWC). There is not much coning or advancing of water in the secondary porosity system. This paper presents the dynamic features of the reservoir and demonstrates how the simulation model was calibrated using all available information, in particular, the pressure buildups.