The knowledge of variations in root canal morphology is essential for a successful endodontic outcome. Contralateral mandibular molar with six root canals is a rare entity. Root canal treatment of mandibular molars with aberrant canal configuration can be diagnostically and technically challenging. While dealing with variant mandibular molars, mishaps may happen. This case report describes variations in contralateral mandibular molars and also an endodontic mishap while managing them.

No abstract

Introduction: Polymerisation shrinkage stresses developed during curing of adhesive resin cements may cause debonding at the margins of cavity leading to microgap formation with secondary caries and consequently restorative failure. Thus, a restoration should have good marginal integrity and wear resistance to obtain high success with clinical longevity. Aim: To compare the influence of thermo-mechanical stresses on marginal quality and wear of class II Mesio-Occluso-Distal (MOD) restorations filled with Solare Sculpt or Cention N. Materials and Methods: An in vitro study was conducted at GITAM Dental College and Hospital, Visakhapatnam on 80 human extracted mandibular molars by preparing mesio-occlusal-distal class two cavities that restored either with Solare Sculpt or Cention N resin composites. Baseline evaluations were recorded for marginal gaps (in μm) through Scanning Electron Microscope (SEM), and the weights of the samples were recorded by an electronic balancing instrument to measure the amount of wear (in grams). Following thermo-mechanical cyclic loading, all the restored teeth were evaluated again to record the same parameters. The statistical analysis was done using Statistical Package for the Social Sciences (SPSS) programme for windows version 22.0 (IBM, NY) software. An independent t-test for intergroup comparison and a dependent t-test for intragroup comparisons were done to analyse the tested parameters with the significance level established at (p≤0.05). Results: In intergroup comparison, no difference in marginal adaptation was observed before thermo-mechanical loading between two materials with a p-value of 0.3625, but after therm-omechanical loading Cention N exhibited significantly superior marginal adaptation with a p-value of 0.0374. Both the materials have shown a significant difference in the marginal adaptation after thermo-mechanical loading in the intragroup comparison with Cention N (0.0002) and Solare sculpt (0.0001) p-values. The wear rate was not different statistically between the materials with a p-value of 0.7144 before thermo-mechanical loading and 0.2285 after thermo-mechanical loading. Conclusion: Marginal adaptation of Cention N was superior to Solare Sculpt, whereas both the materials exhibited a similar wear rate.

Aim: The aim is to assess and compare the microcrack formation in radicular dentin after obturating the root canals with cold lateral condensation (CLC), warm vertical condensation (WVC), and injectable gutta-percha (IGP) techniques using micro-computed tomography (CT). Materials and Methods: Human extracted mandibular premolar teeth ( n = 60) were haphazardly assigned based on the obturation technique into three experimental groups ( n = 20 each). Root canals are cleaned and shaped with M Two rotary files and 3% sodium hypochlorite irrigant. Cross-sectional images were taken with Micro-CT to record the baseline defects present on root samples. After root canal obturation either with CLC or WVC or injectable obturation techniques, micro-CT images were captured again to analyze the increase in the number and type of dentinal defects. Statistical analysis of data was performed using the Mann–Whitney U test and the Mcnemar test at 5% significance level. Results: An increase in the number of radicular micro-cracks was identified in samples obturated with lateral condensation technique (1.66%). No change in the percentage of micro-cracks was recorded after obturation with warm vertical or injectable guttapercha (IGP) techniques ( P > 0.05). The three obturation techniques were not statistically different in the occurrence of micro-cracks after obturation. Conclusion: The three obturating techniques tested showed no significant increase in radicular dentin defects' occurrence or propagation.

No abstract