A turbulent lifted slot-jet flame is studied using direct numerical simulation (DNS). A one-step chemistry model is employed with a mixture-fraction-dependent activation energy which can reproduce qualitatively the dependence of the laminar burning rate on the equivalence ratio that is typical of hydrocarbon fuels. The basic structure of the flame base is first examined and discussed in the context of earlier experimental studies of lifted flames. Several features previously observed in experiments are noted and clarified. Some other unobserved features are also noted. Comparison with previous DNS modelling of hydrogen flames reveals significant structural differences. The statistics of flow and relative edge-flame propagation velocity components conditioned on the leading edge locations are then examined. The results show that, on average, the streamwise flame propagation and streamwise flow balance, thus demonstrating that edge-flame propagation is the basic stabilisation mechanism. Fluctuations of the edge locations and net edge velocities are, however, significant. It is demonstrated that the edges tend to move in an essentially two-dimensional (2D) elliptical pattern (laterally outwards towards the oxidiser, then upstream, then inwards towards the fuel, then downstream again). It is proposed that this is due to the passage of large eddies, as outlined in Su et al. (Combust. Flame, vol. 144 (3), 2006, pp. 494-512). However, the mechanism is not entirely 2D, and out-of-plane motion is needed to explain how flames escape the high-velocity inner region of the jet. Finally, the time-averaged structure is examined. A budget of terms in the transport equation for the product mass fraction is used to understand the stabilisation from a time-averaged perspective. The result of this analysis is found to be consistent with the instantaneous perspective. The budget reveals a fundamentally 2D structure, involving transport in both the streamwise and transverse directions, as opposed to possible mechanisms involving a dominance of either one direction of transport. It features upstream transport balanced by entrainment into richer conditions, while on the rich side, upstream turbulent transport and entrainment from leaner conditions balance the streamwise convection.

In diesel engines, combustion is initiated by a two-staged autoignition that includes both low-and high-temperature chemistry. The location and timing of both stages of autoignition are important parameters that influence the development and stabilisation of the flame. In this study, a twodimensional direct numerical simulation (DNS) is conducted to provide a fully resolved description of ignition at diesel engine-relevant conditions. The DNS is performed at a pressure of 40 atmospheres and at an ambient temperature of 900 K using dimethyl ether (DME) as the fuel, with a 30 species reduced chemical mechanism. At these conditions, similar to diesel fuel, DME exhibits two-stage ignition. The focus of this study is on the behaviour of the low-temperature chemistry (LTC) and the way in which it influences the high-temperature ignition. The results show that the LTC develops as a "spotty" first-stage autoignition in lean regions which transitions to a diffusively supported cool-flame and then propagates up the local mixture fraction gradient towards richer regions. The cool-flame speed is much faster than can be attributed to spatial gradients in firststage ignition delay time in homogeneous reactors. The cool-flame causes a shortening of the second-stage ignition delay times compared to a homogeneous reactor and the shortening becomes

No abstract

This paper presents a statistical analysis of edge flames in a turbulent lifted flame using direct numerical simulation (DNS). To investigate the dynamics of edge flames, a theoretical framework describing the edge-flame propagation velocity as a function of propagation velocities of mixture-fraction and product-mass fraction iso-surfaces at the flame base is used. The correlations between these propagation velocities and several other variables are then studied, including iso-surface curvatures, iso-surface orientations, strain rates, scalar dissipation rate and gradients of product mass fraction. The contribution of these parameters to the overall behaviour of the edge flame is also investigated using conditional averaging on two-dimensional spatial locations at the flame base. The analysis reveals that the tangential and normal strain rates in addition to the curvatures and scalar dissipation rates have significant contributions to the overall behaviour of the edge flame. The elliptical motion of the flame base described in our earlier study [1] is extended to provide a clearer picture of how these various parameters affect the large fluctuations of edge-flame velocity observed at the flame base.

This paper presents an analysis of the energy transported by disturbances in gaseous combustion. It extends the previous work of Myers (J. Fluid Mech., vol. 226, 1991, 383–400) and so includes non-zero mean-flow quantities, large-amplitude disturbances, varying specific heats and chemical non-equilibrium. This extended form of Myers’ ‘disturbance energy’ then enables complete identification of the conditions under which the famous Rayleigh source term can be derived from the equations governing combusting gas motion. These are: small disturbances in an irrotational, homentropic, non-diffusive (in terms of species, momentum and energy) and stationary mean flow at chemical equilibrium. Under these assumptions, the Rayleigh source term becomes the sole source term in a conservation equation for the classical acoustic energy. It is also argued that the exact disturbance energy flux should become an acoustic energy flux in the far-field surrounding a (reacting or non-reacting) jet. In this case, the volume integral of the disturbance energy source terms are then directly related to the area-averaged far-field sound produced by the jet. This is demonstrated by closing the disturbance energy budget over a set of aeroacoustic, direct numerical simulations of a forced, low-Mach-number, laminar, premixed flame. These budgets show that several source terms are significant, including those involving the mean-flow and entropy fields. This demonstrates that the energetics of sound generation cannot be examined by considering the Rayleigh source term alone.