Capillary electrophoresis (CE) and fluorescence correlation spectroscopy (FCS) were employed to determine electrophoretic mobilities and hydrodynamic sizes of three humic substances (IHSS aquatic fulvic acid (FA), IHSS aquatic humic acid (HA), and IHSS peat humic acid (PHA)) as a function of pH and ionic strength. A slight aggregation corresponding to the formation of dimers and trimers was observed at low pH using fluorescence correlation spectroscopy (FCS). For example, for the peat humic acid, diffusion coefficients decreased from 2.1 x 10(-10) m2 s(-1) at pH 4 to 2.4 x 10(-10) m2 s(-1) at pH 11. For all three humic substances, electrophoretic mobilities were also shown to decrease significantly below pH 6. Calculated zeta potentials observed at high pH of -69 mV (FA), -62 mV (HA), and -63 mV (PHA) decreased to -39, -50, and -47 mV, respectively, under slightly acidic pH (4.5-4.8) conditions. No evidence of ionic strength induced aggregation was found using fluorescence correlation spectroscopy (FCS); diffusion coefficients increased slightly (<25%) with increasing ionic strength (up to 1 M). Negative electrophoretic mobilities decreased to a maximum measured ionic strength of 0.18 M. Above this ionic strength, no peaks were observed due to an increased HS adsorption to the capillary wall and an important decrease in electroosmotic flow. Interpretation of electrophoretic mobilities determined by CE is complicated by the fact that under certain conditions, HS appeared to be complexed by CE buffer systems, including MES, BES, and AMPSO.

The electrostatic, hydrodynamic and conformational properties of aqueous solutions of succinoglycan have been analyzed by fluorescence correlation spectroscopy (FCS), proton titration, and capillary electrophoresis (CE) over a large range of pH values and electrolyte (NaCl) concentrations. Using the theoretical formalism developed previously for the electrokinetic properties of soft, permeable particles, a quantitative analysis for the electrohydrodynamics of succinoglycan is performed by taking into account, in a self-consistent manner, the measured values of the diffusion coefficients, electric charge densities, and electrophoretic mobilities. For that purpose, two limiting conformations for the polysaccharide in solution are tested, i.e. succinoglycan behaves as (i) a spherical, random coil polymer or (ii) a rodlike particle with charged lateral chains. The results show that satisfactory modeling of the titration data for ionic strengths larger than 50 mM can be accomplished using both geometries over the entire range of pH values. Electrophoretic mobilities measured for sufficiently large pH values (pH > 5-6) are in line with predictions based on either model. The best manner to discriminate between these two conceptual models is briefly discussed. For low pH values (pH < 5), both models indicate aggregation, resulting in an increase of the hydrodynamic permeability and a decrease of the diffusion coefficient.

No abstract