This paper presents four topologies of voltage-mode un-terminated IO cells in 28-nm CMOS for singleended rail-to-rail signaling over a passive interposer die in 2.5D configuration for >1Gbps data rates. The presented design explores the existing IO design-space from a 2.5D viewpoint, optimizing existing topologies from area, speed, power and protection perspectives, with a higher degree of configurability in the form of pre-emphasis and slew-rate control. The transmitter (TX) embeds pre-emphasis to enhance high-frequency components of the signal for longer low-pass natured channels. The TX also implements slew-rate control to minimize reflections on shorter channels because of impedance discontinuities and also to minimize simultaneous switching noise. Level-shifting capability embedded in the receiver (RX) enables multi-technology interfacing where different dies are signaling at their core voltages (range: 0.7 V-1.8 V) instead of following a particular signaling standard. The measurement results of the transceivers, over a interposer of length of 3.5 mm, demonstrate ±5% duty-cycle distortion with 700 μW at 500 MHz/0.8-V-signaling on the channel with jitter of 20 ps, ±10% duty-cycle distortion with 1.8 mW at 1Gbps/0.9-V signaling with jitter of 20 ps, ±10% duty-cycle distortion with 2 mW at 2Gbps/0.7-V signaling for 1-V receiver core voltage with a jitter of 10 ps. of limiter material or functional errors because of electro-thermal coupling or excessive leakage currents which can form a positive feedback loop with the temperature leading to thermal run-away problem [10,11]. Moreover, the thermal expansion coefficients of TSV material and substrate are different, which can result in large temperature induced mechanical stress again leading to nonuniform distribution of delay across the area [5].Recently, 2.5D IC stacking has emerged as a viable alternative because of its higher mechanical and thermal reliability with a comparable interconnect density [10,12,13]. Several flip-chip dies are attached with fine-pitch micro-bumps to a single passive interposer die also known as throughsilicon-interposer (TSI) communication. This interposer die allows connections between adjacently placed multi-technology dies as well as connections to the package, providing low interconnect delay, high-bandwidth, multi-technology interfacing and reduced ESD protection requirements for die-to-die connections [14]. Moreover, although incurring the cost of adding a passive Si interposer, TSI avoids the issues faced by TSV based 3D configuration related to the high-temperature gradients because of poor thermal distribution, difficult IO planning, large keep-out areas and reliable manufacturing [10,13,15,16]. When compared with traditional backplane through-PCB interconnections which span lengths of few inches (>25 cm), TSI interconnects are much shorter (few mm) in length [2], which is one of the main reasons for their enhanced performance. For example, at 5 Gbps a 25-cm-long PCB track suffers from approximately 20-dB additional channel l...