No abstract

No abstract

Purpose In line with the recent development of flip-chip reliability and underfill process, this paper aims to comprehensively investigate the effect of different hourglass shape solder joint on underfill encapsulation process by mean of experimental and numerical method. Design/methodology/approach Lattice Boltzmann method (LBM) numerical was used for the three-dimensional simulation of underfill process. The effects of ball grid arrays (BGA) encapsulation process in terms of filling time of the fluid were investigated. Experiments were then carried out to validate the simulation results. Findings Hourglass shape solder joint has shown the shortest filling time for underfill process compared to truncated sphere. The underfill flow obtained from both simulation and experimental results are found to be in good agreement for the BGA model studied. The findings have also shown that the filling time of Hourglass 2 with parabolic shape gives faster filling time compared to the Hourglass 1 with hemisphere angle due to bigger cross-sectional area of void between the solder joints. Practical implications This paper provides reliable insights to the effect of hourglass shape BGA on the encapsulation process that will benefit future development of BGA packages. Originality/value LBM numerical method was implemented in this research to study the flow behaviour of an encapsulation process in term of filling time of hourglass shape BGA. To date, no research has been found to simulate the hourglass shape BGA using LBM.

The conventional capillary underfill process has been a common practice in the industry, somehow the process is costly and time consuming. Thus, no-flow underfill process is developed to increase the effective lead time production since it integrates the simultaneous reflow and cure of the solder interconnect and underfill. This paper investigates the effect of different dispense patterns of no-flow underfill process by mean of numerical and experimental method. Finite volume method (FVM) was used for the three-dimensional simulation to simulate the compression flow of the no-flow underfill. Experiments were carried out to complement the simulation validity and the results from both studies have reached a good agreement. The findings show that of all three types of dispense patterns, the combined shape dispense pattern shows better chip filling capability. The dot pattern has the highest velocity and pressure distribution with values of 0.0172 m/s and 813 Pa, respectively. The high-pressure region is concentrated at the center of the chip and decreases out towards the edge. Low in pressure and velocity flow factor somehow lead to issue associated to possibility of incomplete filling or void formation. Dot dispense pattern shows less void formation since it produces high pressure underfill flow within the BGA. This paper provides reliable insight to the industry to choose the best dispense pattern of recently favorable no-flow underfill process.

No abstract