No abstract

No abstract

No abstract

EHD printing is an advanced deposition technology that is commonly utilized for the direct manufacture of electrical devices. In this study, meander-type resistive electrodes consisting of silver nanoparticles were printed directly on rigid glass and flexible polyethylene terephthalate (PET) substrates. High-resolution patterns of ≈50 µm linewidth were successfully printed on untreated surfaces utilizing a bigger nozzle of 100 µm inner diameter after improving the experimental settings. The manufactured electrodes were evaluated and used as Resistance Temperature Detectors (RTDs) and micro-heaters in a systematic manner. The temperature sensors performed well, with a Temperature Coefficient of Resistivity (TCRs) of 11.5 × 10−3/°C and 13.3 × 10−3/°C, for glass and PET substrates, respectively, throughout a wide temperature range of 100 °C and 90 °C. Furthermore, the RTDs had a quick response and recovery time, as well as minimal hysteresis. The electrodes’ measured sensitivities as micro-heaters were 3.3 °C/V for glass and 6.8 °C/V for PET substrates, respectively. The RTDs were utilized for signal conditioning in a Wheatstone bridge circuit with a self-heating temperature of less than 1 °C as a practical demonstration. The micro-heaters have a lot of potential in the field of soft wearable electronics for biomedical applications, while the extremely sensitive RTDs have a lot of potential in industrial situations for temperature monitoring.

Temperature sensors based on the principle of a change of resistance are fabricated on polyethylene terephthalate (PET) substrates using a silver nanoparticles (AgNPs)-based ink using a bespoke drop-on-demand (DoD) electrohydrodynamic (EHD) printer. Two sensors consisting of either a single or double layer of silver were deposited using EHD printing and were found to exhibit an internal resistance of a few hundred ohms for the double-layer sensor compared to 1 kΩ for the single-layer sensor. The achieved pattern width was almost half the size of nozzle internal diameter (160 μm), and printed without treatment of substrate and nozzle. The sensors were characterized over a temperature range of 20°C to 110°C. Both sensors showed a linear behavior with low hysteresis within the temperature ranges considered in this study and are found to recover the nominal resistance value with good reproducibility. The double-layer sensor showed high sensitivity with a temperature coefficient of resistance (TCR) of 3.4×10-3 ℃−1, which is an order of magnitude larger than that observed for the single-layered sensor with a TCR of 8.41×10-4 ℃−1. The sensors were also tested in a controlled humid environment and results are presented on the dependence of the internal resistance on the level of humidity. The proposed flexible printed sensors are promising for temperature monitoring systems and wearable technologies.