Microwave-assisted organic synthesis is a quickly expanding field of research. The fast non-contact (super)heating of the reaction mixtures has already resulted in many examples of increased reaction rates and improved yields. However, the number of investigations focusing on microwave-assisted polymerizations, and especially living/controlled polymerizations, is still limited. Following our recent success in accelerating the cationic ring-opening polymerization of 2-oxazolines, we report here our studies on the cationic polymerization of a series of linear 2-alkyl-2-oxazolines under microwave irradiation. The effect of chain length on the polymerization kinetics was investigated. Moreover, the microwave polymerization of 2-ethyl-2-oxazoline was further investigated by 1 H-NMR spectroscopy to determine the active species during the polymerization. Besides the microwave polymerization of the linear 2-alkyl-2-oxazoline monomers, the thermal and surface properties of the resulting polymers were investigated by DSC and contact-angle measurements to study the effect of side-chain length on the polymer properties.

The nitroxide-mediated copolymerization of 2-hydroxypropyl acrylate (HPA) with N-acryloylmorpholine (Amor) or N,N-dimethylacrylamide (DMA) was investigated using N-tert-butyl-N-(1′-diethylphosphono-2,2′-dimethylpropyl)-O-(2-carboxyl-prop-2-yl) (BlocBuilder) alkoxyamine initiator and additional free nitroxide (SG-1). Different reaction conditions, such as the concentration of additional SG-1, were tested to optimize the homopolymerizations using a Chemspeed ASW2000 automated parallel synthesizer. Best control for the homopolymerizations (polydispersity indices of 1.2−1.3) of all three monomers was achieved using 20% additional SG-1 (relative to the initiator) at a reaction temperature of 110 °C for 2 M solutions in N,N -dimethylformamide and a monomer/initiator ratio of 100/1. Libraries of P(Amor-stat-HPA) and P(DMA-stat-HPA) were synthesized with 0−100 mol % HPA with 10 mol % increments using the optimized conditions obtained for the homopolymerizations. The resulting polymers had narrow molecular weight distributions, and their compositions, determined using 1H NMR spectroscopy and elemental analysis, were close to the theoretical compositions. In addition, all copolymers of both libraries had single glass transition temperatures (T g), and the transition temperatures decreased from the T g of P(Amor) (147 °C) and P(DMA) (111 °C) to the T g of P(HPA) (22 °C) with increasing HPA content. The cloud point of P(HPA) showed concentration dependence as well as a concentration dependent hysteresis. The cloud points of aqueous solutions of the copolymer libraries could be tuned from 21.4 to 88.0 °C and to 82.9 °C for P(Amor-stat-HPA) and P(DMA-stat-HPA), respectively, at a concentration of 1 wt %. LCST behavior was observed for copolymers with >40 wt % HPA in P(Amor-stat-HPA) and >55 wt % HPA in the P(DMA-stat-HPA) library.

The systematical kinetic investigations of four 2‐substituted‐2‐oxazoline monomers with four initiators at two temperatures and four monomer/initiator ratios are described. To cover this broad range of variables (128 different combinations), an automated synthesizer was used to accelerate the investigations and to provide highly comparable results. With both gas chromatography and gel permeation chromatography, the livingness and the polymerization rates were determined for the different polymerizations. The resulting insights in the kinetics were used for the directed synthesis of truly random copolymers and copolymers with composition drift. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 1830–1840, 2004